P6SMB Datasheet, PDF (1/4 Pages) Taiwan Semiconductor Company, Ltd – Surface Mount Transient Voltage Suppressor

P6SMB Series
Surface Mount Transient Voltage Suppressor
SMB
Features
• For surface mounted applications in order to optimize board space.
• Low profile package
• Built-in strain relief
• Glass passivated junction
• Low inductance
• Typical I_D less than 1.0µA above 10V
• Plastic package has Underwriters Laboratory
Fammability Classification 94V-O
• High temperature soldering : 260°C /10 seconds at terminals
• In compliance with EU RoHS 2002/95/EC directives
Mechanical Data
• Case: JEDEC DO-214AA ,Molded plastic over passivated junction
• Terminals: Solder plated,solderable per MIL-STD-750,Method 2026
• Polarity: Color band denotes positive end (cathode)
• Standard Packaging:12mm tape (EIA-481)
• Weight: 0.003 ounce, 0.093 gram
4.7± 0.25
5.4± 0.2
1.3± 0.2
0.2± 0.05
Dimensions in millimeters
DEVICES FOR BIPOLAR APPLICATIONS
For Bidirectional use C or CA Suffix for types
Electrical characteristics apply in both directions.
MAXIMUM RATINGS AND CHARACTERISTICS
Rating at 25°Cambient temperature unless otherwise specified. Resistive or inductive load, 60Hz.
For Capacitive load derate current by 20%.
Rating
Peak Pulse Power Dissipation on 10/1000uS waveform (Notes 1,2, Fig.1)
Peak Forward Surge Current 8.3ms single half sine-wave
superimposed on rated load (JEDEC Method) (Notes 2,3)
Peak Pulse Current on 10/1000us waveform(Note 1)Fig.3
Operating Junction and Storage Temperature Range
Symbol
P_PPM
I_FSM
I_PPM
T_J,T_STG
Value
600
100
see Table 1
-55 to +150
Units
Watts
Amps
Amps
O_C
NOTES:
1. Non-repetitive current pulse, per Fig.3 and derated above T_A = 25 ^OC per Fig. 2.
2. Mounted on 5.0mm² (0.13mm thick) land areas.
3. Measured on 8.3ms, single half sine-wave or equivalent square wave, duty cycle = 4 pulses per minute
maximum.
http://www.luguang.cn
mail:[e-mail]