WB45NBT Datasheet, PDF (6/25 Pages) Laird Tech Smart Technology – Removed pending status of WFA and CCX

WB45NBT
Datasheet
Feature
(1.8 V signal level)
USB Interfaces
Two Wire Interface
(1.8V signal level)
Debug Interface
Digital GPIO
(1.8 V signal level)
Analog GPIO
(3.3 V signal level)
PCM interface
Antenna Interface
Wi-Fi Interface
Bluetooth Interface
Processor Chip Set
Operating System
Memory
Storage
Input Voltage
Requirements
Current Consumption
Note: These current
consumption
measurements
were taken using
Linux kernel
version 3.8.0.
Note: Standby refers to
the radio
operating while
connected to an
AP but not
transmitting or
receiving.
Description
Configurable USB Host port/Device port to support USB full speed and high
speed data rates
Two-wire I2C (Inter-IC)
Two-wire UART (console) for debug purpose
4 digital General Purpose I/O (GPIO)
4 analog General Purpose I/O (GPIO)
13-bit or 16-bit linear, 8-bit μ-law or A-law companded sample formats
2 Hirose U.FL connectors for Wi-Fi (Main) and BT (Aux) separately, 50 ohm
Note: Wi-Fi and BT sharing a single antenna is NOT currently supported.
Qualcomm Atheros AR6003 1X1 802.11 a/b/g/n on 20 MHz bandwidth
CSR CSR8510 Bluetooth 4.0 dual-mode (EDR+BLE)
Atmel 400 MHz ARM 9, P/N AT91SAM9G25-CU
Embedded Linux, 3.x kernel
64 MB LPDDR
128 MB SLC NAND flash
3.3 VDC +/-5% (Backup) 3.3 VDC ±5% (system) 1.8 VDC +/-2% (Memory and I/O
interface)
Note: Voltage ripple must be less than 30 mV.
Mode
1.8 V
Average
3.3 V
Average
802.11a
Transmit
78
325
Receive
95
71
Standby
13
56
802.11b
Transmit
74
278
Receive
91
57
Standby
13
56
802.11g
Transmit
80
265
Receive
91
57
Standby
13
56
802.11n (2.4 GHz) Transmit
80
285
Receive
91
57
Standby
13
56
802.11n (5 GHz) Transmit
78
335
Receive
95
70
Standby
13
56
Embedded Wireless Solutions Support Center:
http://ews-support.lairdtech.com
www.lairdtech.com/wireless
6
© Copyright 2016 Laird. All Rights Reserved
Americas: [phone]
Europe: [phone]
Hong Kong: [phone]