COATING-300 Datasheet, PDF (2/2 Pages) Laird Tech Smart Technology – Two part Polyurethane Coating

Eccosorb®Coating 300
INSTRUCTIONS FOR USE
• The system has to be applied in dry conditions
• Make sure that the surface to be coated is clean and free of oil and dusts.
• The temperature should be higher than 15 °C during application and curing.
• Thoroughly mix the paint until homogeneous.
• Add the catalyst in the correct weight ratio, see Typical Properties Table above.
• Pot life is 2 hours.
• It is recommended to build up the total thickness of the coating in steps of 100 - 150 µm with
flash times of one hour between steps. The total layer should be cured for 24 hours minimum
at room temperature. For layers thicker than 500 µm, the curing steps should be 24 hours
after each 500 µm layer.
• For slightly accelerated curing of the final thickness, 2 hours at 80 °C is recommended. Flash
point between layer applications must be maintained to ensure that the solvent has
evaporated.
• For thinning, small amount of MEK may be used. Extended flash points are required to
evaporate solvent.
• Thickness note :
Eccosorb Coating 300 is applied in thin layers until the correct thickness is obtained. Correct
thickness is determined on a case-by-case situation depending on application and frequency of
operation.
RFP-DS-COATING300 011216
Any information furnished by Laird Technologies, Inc. and its agents is believed to be accurate and reliable. All specifications are subject to change without notice. Responsibility for the use and application of Laird Technologies materials rests with the
2
end user. Laird Technologies makes no warranties as to the fitness, merchantability, suitability or non- infringement of any Laird Technologies materials or products for any specific or general uses. Laird Technologies shall not be liable for incidental or
consequential damages of any kind. All Laird Technologies products are sold pursuant to the Laird Technologies’ Terms and Conditions of sale in effect from time to time, a copy of which will be furnished upon request. © Copyright 2015 Laird
Technologies, Inc. All Rights Reserved. Laird, Laird Technologies, the Laird Technologies Logo, and other marks are trademarks or registered trademarks of Laird Technologies, Inc. or an affiliate company thereof. Other product or service names may be
the property of third parties. Nothing herein provides a license under any Laird Technologies or any third party intellectual property rights.