13-211-NF Datasheet, PDF (1/1 Pages) Laird Tech Smart Technology – Good adhesion

Eccostock®13-211-NF
One-Part Solvent Based Non-Flammable
Contact Adhesive
ONE-PART SOLVENT BASED CONTACT ADHESIVE
Eccostock 13-211-NF is a one-part, general purpose, non-flammable neoprene adhesive that is
solvent based. Eccostock 13-211-NF provides good adhesion to urethane foams, wood,
aluminium, rubber, galvanized steel, and most plastics.
FEATURES AND BENEFITS
• Good adhesion
• Sprayable
SPECIFICATIONS
MARKETS
• Commercial Telecom
• Security and Defense
• Test & Measurement
TYPICAL PROPERTIES
Application Temperature °C (°F)
Density, g/cc
Dielectric Constant
Tack Time, Depending on Conditions
Estimated Coverage Per Gallon
Shelf life
APPLICATIONS
ECCOSTOCK ADHESIVE 13-211-NF
15.5 – 37.5 (60 – 100)
1.27
~3.0
2 – 60 minutes
110 square feet
1 Year
• Eccostock 13-211-NF is specifically designed and only recommended for bonding our
Eccosorb® foam products such as Eccosorb®AN, ANW, LS, QR, HR and CV.
AVAILABILITY
• Eccostock 13-211-NF is standard sold by the Quart (2.5 lb), Gallon (10 lb) and 5 Gallon Pail
(50 lb)
• Country of Origin : United States
INSTRUCTIONS FOR USE
Americas: +1.866.928.8181
Europe: +49.(0)8031.2460.0
Asia: +86.755.2714.1166
www.lairdtech.com
• All surfaces to be bonded with Eccostock 13-211-NF should be cleaned to remove all oil,
grease and foreign materials. A recommended solvent is Methylene Chloride which should
only be used in a well ventilated area.
Note: The use of solvents with the Eccosorb® foam products is not recommended. Therefore,
the removal of foreign materials should be done with an air stream or vacuum.
• Eccostock 13-211-NF may be applied by brush, roller or spray equipment.
For spraying, a pressure-type pot spray system is recommended.
• Shake the container well before opening and mix thoroughly before use.
• Coat both surfaces to be bonded with the Eccostock 13-211-NF and allow one surface to dry
for a period of time till nearly tack free.
• For optimum adhesion it is necessary that one surface be relatively dry to the touch and the
other surface be tacky at the time when the surfaces are mated.
Apply sufficient pressure to ensure good contact on the mating surfaces.
RFP-DS-13211-NF 120315
Any information furnished by Laird Technologies, Inc. and its agents is believed to be accurate and reliable. All specifications are subject to change without notice. Responsibility for the use and application of Laird Technologies materials rests with the end user. Laird
Technologies makes no warranties as to the fitness, merchantability, suitability or non- infringement of any Laird Technologies materials or products for any specific or general uses. Laird Technologies shall not be liable for incidental or consequential damages of any
kind. All Laird Technologies products are sold pursuant to the Laird Technologies’ Terms and Conditions of sale in effect from time to time, a copy of which will be furnished upon request. © Copyright 2015 Laird Technologies, Inc. All Rights Reserved. Laird, Laird
Technologies, the Laird Technologies Logo, and other marks are trademarks or registered trademarks of Laird Technologies, Inc. or an affiliate company thereof. Other product or service names may be the property of third parties. Nothing herein provides a license
under any Laird Technologies or any third party intellectual property rights.