SL1010A075 Datasheet, PDF (3/3 Pages) Littelfuse – Gas Discharge Tubes

Gas Discharge Tubes
SL1010A Series
Soldering Parameters - Reflow Soldering (Surface Mount Devices)
Reflow Condition
Pb-free assembly
- Temperature Min (T_s(min))
Pre Heat - Temperature Max (T_s(max))
- Time (Min to Max) (t_s)
Average Ramp-up Rate (Liquidus Temp
(T_L) to peak)
T_S(max) to T_L - Ramp-up Rate
Reflow
- Temperature (T_L) (Liquidus)
- Temperature (t_L)
Peak Temperature (T_P)
Time within 5°C of Actual Peak
Temperature (t_p)
Ramp-down Rate
Time 25°C to Peak Temperature (T_P)
Do not exceed
150°C
200°C
60 – 180 seconds
3°C/second max.
5°C/second max.
217°C
60 – 150 seconds
260^+0/-5 °C
10 – 30 seconds
6°C/second max.
8 minutes max.
260°C
T_P
T_L
T_S(max)
Ramp-up
T_S(min)
Preheat
t_S
25
time to peak temperature
(t 25ºC to peak)
Soldering Parameters - Hand Soldering
Solder Iron Temperature: 350° C +/- 5°C
Heating Time: 5 seconds max.
Packaging
'SM' Type Surface Mount Items: Packaged tape and reel carrier, 900 pcs/reel (specifications below)
t_P
Critical Zone
TL to TP
t_L
Ramp-down
Time
Dimensions are in millimeters [and inches]
Dimensions are in millimeters [and inches]
275.0
[10.83]
100.0
[3.94]
76.0
[2.99]
25.0
[0.98]
17.7
[0.697]
Direction of Feed
Part Numbering System and Ordering Information
SL1010A XXX XX
SL1010A Series
Voltage
Pin Configuration
F = with Failsafe (Packed in carrier and tape, 900pcs/reel)
SM = Surface Mount (Packed in carrier and tape, 900pcs/reel)
SMF = Surface Mount with Failsafe (Packed in carrier and tape, 900pcs/reel)
© 2015 Littelfuse, Inc.
Specifications are subject to change without notice.
Revised: 11/06/15