60R010_06 Datasheet, PDF (3/5 Pages) Littelfuse – POLYFUSE® Resettable PTCs

POLYFUSE^® Resettable PTCs
Radial Leaded
Soldering Parameters - Wave Soldering
Pre-Heating Zone
Soldering Zone
Cooling Zone
Refer to the condition
recommended by the
flux manufacturer.
Max. ramping rate
should not exceed
4°C/Sec.
Max. solder temperature
should not exceed
260°C
Cooling by natural
convection in air.
Physical Specifications
Lead Material
.20-.40A: Tin-plated copper clad steel
.50-3.75A: Tin-plated copper
Soldering
Characteristics
Solderability per MIL-STD-202,
Method 208E
Insulating Material
Cured, flame retardant epoxy polymer
meets UL94V-0 requirements.
Device Labeling
Marked with LF, voltage, current rating,
and date code.
Soldering
260
220
Preheating
190
160
Cooling
0
60 min.
5 max.
Time(s)
Environmental Specifications
Operating/Storage
Temperature
-40°C to +85°C
Maximum Device Surface
Temperature in Tripped State
125°C
Passive Aging
+85°C, 1000 hours
±5% typical resistance change
Humidity Aging
+85°C, 85%R.H. 1000 hours
±5% typical resistance change
Thermal Shock
+85°C to -40°C 10 times
±5% typical resistance change
Solvent Resistance
MIL-STD-202, Method 215F
60R Series
Specifications are subject to change without notice.

Electronics Designers Guide
www.littelfuse.com
©2006 Littelfuse