P6002ADL Datasheet, PDF (1/2 Pages) Littelfuse – High Surge Current Three-pin SIDACtor

High Surge Current Three-pin SIDACtor® Device
RoHS
1
This SIDACtor device is a 1000 A solid state protection device offered in a TO-220 package.
(T)
2 ^{It protects equipment located in the severe surge environment of CATV (Community}
3
(G) _{Antenna TV) systems and antenna locations.}
(R)
Electrical Parameters
Part
Number *
P6002ADL
V_DRM
Volts
550
V_S
Volts
700
V_T
Volts
5.5
I_DRM
µAmps
5
I_S
mAmps
800
I_T
Amps
2.2
* “L” in part number indicates RoHS compliance. For non-RoHS compliant device, delete “L” from part number.
For surge ratings, see table below.
I_H
mAmps
50
Electrical Parameters
Part
Number *
P3100ADL
V_DRM
Volts
280
V_S
Volts
360
V_T
Volts
5.5
I_DRM
µAmps
5
I_S
mAmps
800
I_T
Amps
2.2
I_H
mAmps
150
* “L” in part number indicates RoHS compliance. For non-RoHS compliant device, delete “L” from part number.
For surge ratings, see table below.
General Notes:
• All measurements are made at an ambient temperature of 25 °C. I_PP applies to -40 °C through +85 °C temperature range.
• I_PP is a repetitive surge rating and is guaranteed for the life of the product.
• Listed SIDACtor devices are bi-directional. All electrical parameters and surge ratings apply to forward and reverse polarities.
• V_DRM is measured at I_DRM.
• V_S is measured at 100 V/µs.
• Special voltage (V_S and V_DRM) and holding current (I_H) requirements are available upon request.
Surge Ratings in Amps
Series
D
8x20 *
1.2x50 **
Amps
1000
I_PP
10x1000 *
10x1000 **
Amps
250
I_TSM
50 / 60 Hz
Amps
120
di/dt
Amps/µs
500
* Current waveform in µs
** Voltage waveform in µs
Note: P6002AD is shown. P3100AD has no center lead.
Telecom Design Guide • © 2006 Littelfuse
3 - 85
www.littelfuse.com