P6002AD Datasheet, PDF (1/2 Pages) Littelfuse – High Surge Current SIDACtor Device

High Surge Current SIDACtor Device
High Surge Current SIDACtor Device
1
This SIDACtor device is a 1000 A solid state protection device offered in a TO-220 package.
(T)
2 ^{It protects equipment located in the severe surge environment of Community Antenna TV}
3
(G) _{(CATV) applications.}
(R)
This device can replace the gas tubes traditionally used for station protection because
SIDACtor devices have much tighter voltage tolerances.
Electrical Parameters
Part
Number *
P6002AD
V_DRM
Volts
550
* For surge ratings, see table below.
V_S
Volts
700
V_T
Volts
5.5
I_DRM
µAmps
5
I_S
mAmps
800
I_T
Amps
2.2
I_H
mAmps
50
C_O
pF
Pins 1-3
60
Electrical Parameters
Part
Number *
P3100AD
V_DRM
Volts
280
V_S
Volts
360
V_T
Volts
5.5
I_DRM
µAmps
5
I_S
mAmps
800
I_T
Amps
2.2
I_H
mAmps
120
C_O
pF
Pins 1-3
115
* For surge ratings, see table below.
General Notes:
• All measurements are made at an ambient temperature of 25 °C. I_PP applies to -40 °C through +85 °C temperature range.
• I_PP is a repetitive surge rating and is guaranteed for the life of the product.
• Listed SIDACtor devices are bi-directional. All electrical parameters and surge ratings apply to forward and reverse polarities.
• V_DRM is measured at I_DRM.
• V_S is measured at 100 V/µs.
• Special voltage (V_S and V_DRM) and holding current (I_H) requirements are available upon request.
• Off-state capacitance (C_O) is measured at 1 MHz with a 2 V bias and is a typical value.
Surge Ratings
Series
D
I_PP
8x20 µs
Amps
1000
I_PP
10x1000 µs
Amps
250
I_TSM
60 Hz
Amps
120
di/dt
Amps/µs
500
http://www.littelfuse.com
[phone]
2 - 60
© 2004 Littelfuse, Inc.
SIDACtor^® Data Book and Design Guide