P1900RE Datasheet, PDF (1/2 Pages) Littelfuse – CATV Line Amplifiers/Power Inserters RE SIDACtor Device

CATV Line Amplifiers/Power Inserters RE SIDACtor Device
CATV Line Amplifiers/Power Inserters RE
SIDACtor Device
This SIDACtor device is a 3000 A solid state protection device offered in a non-isolated
1
2 _{TO-220 package. It protects equipment located in the severe surge environment of CATV}
(Community Antenna TV) applications.
In CATV line amplifiers and power inserters, this device can replace the gas tubes
traditionally used for station protection because SIDACtor devices have much tighter
voltage tolerances.
Electrical Parameters
Part
Number *
P1900RE
V_DRM
Volts
140
V_S
Volts
220
V_T
I_DRM
I_S
I_T
I_H
C_O
Volts
µAmps
mAmps
Amps **
mAmps
pF
4
5
800
2.2/25
50
260
* For surge ratings, see table below.
** I_T is a free air rating; heat sink I_T rating is 25 A.
General Notes:
• All measurements are made at an ambient temperature of 25 °C. I_PP applies to -40 °C through +85 °C temperature range.
• I_PP is a repetitive surge rating and is guaranteed for the life of the product.
• Listed SIDACtor devices are bi-directional. All electrical parameters and surge ratings apply to forward and reverse polarities.
• V_DRM is measured at I_DRM.
• V_S is measured at 100 V/µs.
• Special voltage (V_S and V_DRM) and holding current (I_H) requirements are available upon request.
• Off-state capacitance (C_O) is measured at 1 MHz with a 2 V bias and is a typical value.
Surge Ratings
Series
E
I_PP
8x20 µs
Amps
3000
I_TSM
60 Hz
Amps
400
di/dt
Amps/µs
500
http://www.littelfuse.com
[phone]
2 - 66
© 2004 Littelfuse, Inc.
SIDACtor^® Data Book and Design Guide