P0641CA2 Datasheet, PDF (1/2 Pages) Littelfuse – Twin SLIC Protector

Twin SLIC Protector
Twin SLIC Protector
Subscriber Line Interface Circuits (SLIC) are highly susceptible to transient voltages, such
1
as lightning and power cross conditions. To minimize this threat, Teccor provides this dual-
(T)
2 ^{chip, fixed-voltage SLIC protector device.}
3
(G)
(R)
For specific design criteria, see details in Figure 3.29.
Electrical Parameters
Part
Number *
P0641CA2
P0721CA2
P0901CA2
P1101CA2
V_DRM
V_S
Volts
Volts
V_T
V_F
I_DRM
I_S
I_T
I_H
C_O
Pins 1-2, 3-2
Volts
Volts
µAmps mAmps Amps mAmps
pF
58
77
4
5
5
800
1
120
60
65
88
4
5
5
800
1
120
60
75
98
4
5
5
800
1
120
60
95
130
4
5
5
800
1
120
60
* For surge ratings, see table below.
General Notes:
• All measurements are made at an ambient temperature of 25 °C. I_PP applies to -40 °C through +85 °C temperature range.
• I_PP is a repetitive surge rating and is guaranteed for the life of the product.
• V_DRM is measured at I_DRM.
• V_S and V_F are measured at 100 V/µs.
• Special voltage (V_S and V_DRM) and holding current (I_H) requirements are available upon request.
• Off-state capacitance is measured across pins 1-2 or 3-2 at 1 MHz with a 2 V bias. Capacitance across pins 1-3 is approximately
half.
• Parallel capacitive loads may affect electrical parameters.
• Compliance with GR 1089 or UL 60950 power cross tests may require special design considerations. Contact the factory for further
information.
Surge Ratings (Preliminary Data)
Series
A
I_PP
2x10 µs
Amps
150
I_PP
8x20 µs
Amps
150
I_PP
10x160 µs
Amps
90
I_PP
10x560 µs
Amps
50
I_PP
10x1000 µs
Amps
45
I_TSM
60 Hz
Amps
20
di/dt
Amps/µs
500
http://www.teccor.com
[phone]
2 - 54
© 2004 Littelfuse LP
SIDACtor^® Data Book and Design Guide