English
Language : 

P0080SAMCL Datasheet, PDF (1/2 Pages) Littelfuse – MicroCapacitance (MC) SA SIDACtor® Device
MicroCapacitance (MC) SA SIDACtor® Device
RoHS
¨
These DO-214AA SAMC SIDACtor devices are intended for applications sensitive to load
values. Typically, high speed connections, such as Ethernet, xDSL, and T1/E1, require a
lower capacitance. CO values for the MicroCapacitance device are 40% lower than a
standard SA part.
This SAMC SIDACtor series enables equipment to comply with various regulatory
requirements including GR 1089, ITU K.20, K.21, and K.45, IEC 60950, UL 60950, and TIA-
968-A (formerly known as FCC Part 68).
Electrical Parameters
Part
Number *
P0080SAMCL
P0220SAMCL
P0300SAMCL
VDRM
Volts
6
15
25
VS
Volts
25
32
40
VT
Volts
4
4
4
IDRM
µAmps
5
5
5
IS
mAmps
800
800
800
IT
Amps
2.2
2.2
2.2
IH
mAmps
50
50
50
* “L” in part number indicates RoHS compliance. For non-RoHS compliant device, delete “L” from part number.
For surge ratings, see table below.
General Notes:
• All measurements are made at an ambient temperature of 25 °C. IPP applies to -40 °C through +85 °C temperature range.
• IPP is a repetitive surge rating and is guaranteed for the life of the product.
• Listed SIDACtor devices are bi-directional. All electrical parameters and surge ratings apply to forward and reverse polarities.
• VDRM is measured at IDRM.
• VS is measured at 100 V/µs.
• Special voltage (VS and VDRM) and holding current (IH) requirements are available upon request.
Surge Ratings in Amps
0.2x310 * 2x10 * 8x20 *
0.5x700 ** 2x10 ** 1.2x50 **
10x160 *
10x160 **
IPP
10x560 *
10x560 **
5x320 *
9x720 **
10x360 * 10x1000 * 5x310 *
ITSM
10x360 ** 10x1000 ** 10x700 ** 50 / 60 Hz
di/dt
Amps Amps Amps
Amps
Amps Amps Amps
Amps
Amps Amps Amps/µs
A
20
150
150
90
50
75
75
45
75
20
500
* Current waveform in µs
** Voltage waveform in µs
www.littelfuse.com
3-8
© 2006 Littelfuse • Telecom Design Guide