English
Language : 

P0080SAMC Datasheet, PDF (1/2 Pages) Littelfuse – MicroCapacitance (MC) SA SIDACtor Device
MicroCapacitance (MC) SA SIDACtor Device
MicroCapacitance (MC) SA SIDACtor Device
The DO-214AA SA MC SIDACtor series is intended for applications sensitive to load
values. Typically, high speed connections require a lower capacitance. CO values for the
MicroCapacitance device are 40% lower than a standard SA part.
This MC SIDACtor series is used to enable equipment to meet various regulatory
requirements including GR 1089, ITU K.20, K.21, and K.45, IEC 60950, UL 60950, and
TIA-968-A (formerly known as FCC Part 68).
Electrical Parameters
Part
VDRM
VS
VT
IDRM
IS
IT
IH
CO
Number *
Volts
Volts
Volts
µAmps
mAmps
Amps
mAmps
pF
P0080SA MC
6
25
4
5
800
2.2
50
45
P0300SA MC
25
40
4
5
800
2.2
50
25
* For surge ratings, see table below.
General Notes:
• All measurements are made at an ambient temperature of 25 °C. IPP applies to -40 °C through +85 °C temperature range.
• IPP is a repetitive surge rating and is guaranteed for the life of the product.
• Listed SIDACtor devices are bi-directional. All electrical parameters and surge ratings apply to forward and reverse polarities.
• VDRM is measured at IDRM.
• VS is measured at 100 V/µs.
• Special voltage (VS and VDRM) and holding current (IH) requirements are available upon request.
• Off-state capacitance (CO) is measured at 1 MHz with a 2 V bias.
Surge Ratings
Series
A
IPP
2x10 µs
Amps
150
IPP
8x20 µs
Amps
150
IPP
10x160 µs
Amps
90
IPP
10x560 µs
Amps
50
IPP
10x1000 µs
Amps
45
ITSM
60 Hz
Amps
20
di/dt
Amps/µs
500
http://www.littelfuse.com
+1 972-580-7777
2-8
© 2004 Littelfuse, Inc.
SIDACtor® Data Book and Design Guide