B1160CARP Datasheet, PDF (1/2 Pages) Littelfuse – Battrax SLIC Protector

Battrax SLIC Protector
Battrax SLIC Protector
This solid state protection device can be referenced to either a positive or negative voltage
source. The B1xx0C_ is for a -V_REF and the B2050C_ is for a +V_REF. Designed using an
SCR and a gate diode, the B1xx0C_ Battrax begins to conduct at |-V_REF| + |-1.2 V| while the
B2050C_ Battrax begins to conduct at |+V_REF| + |1.2 V|.
For a diagram of a Battrax application, see Figure 3.38.
Pin 2
(Ground)
Pin 3
(-VREF)
Gate
-Battrax
B1xx0C_
Pin 1
(Line)
Pin 3
(+VREF)
+Battrax
B2050C_
Pin 1
(Line)
Pin 2
(Ground)
Electrical Parameters
Part
Number *
B1100C_
B1160C_
B1200C_
B2050C_
V_DRM
Volts
|-V_REF| + |-1.2 V|
|-V_REF| + |-1.2 V|
|-V_REF| + |-1.2 V|
|+V_REF| + |1.2 V|
V_S
Volts
|-V_REF| + |-10 V|
|-V_REF| + |-10 V|
|-V_REF| + |-10 V|
|+V_REF| + |10 V|
V_T
I_DRM
I_GT
I_T
I_H
C_O
Volts µAmps mAmps Amps mAmps pF
4
5
100
2.2
100
50
4
5
100
2.2
160
50
4
5
100
2.2
200
50
4
5
50
2.2
50
50
* For individual “CA” and “CC” surge ratings, see table below.
General Notes:
• All measurements are made at an ambient temperature of 25 °C. I_PP applies to -40 °C through +85 °C temperature range.
• I_PP is a repetitive surge rating and is guaranteed for the life of the product.
• I_PP ratings assume V_REF = ±48 V.
• V_DRM is measured at I_DRM.
• V_S is measured at 100 V/µs.
• Off-state capacitance (C_O) is measured at 1 MHz with a 2 V bias and is a typical value. “CC” product is approximately 2x the listed
value.
• Positive Battrax information is preliminary data.
• V_REF maximum value for the negative Battrax is -200 V.
• V_REF maximum value for the positive Battrax is 110 V.
Surge Ratings
Series
A
C
I_PP
2x10 µs
Amps
150
500
I_PP
8x20 µs
Amps
150
400
I_PP
10x160 µs
Amps
90
200
I_PP
10x560 µs
Amps
60
150
I_PP
10x1000 µs
Amps
50
100
I_TSM
60 Hz
Amps
20
50
di/dt
Amps/µs
500
500
http://www.littelfuse.com
[phone]
2 - 50
© 2004 Littelfuse, Inc.
SIDACtor^® Data Book and Design Guide