RH1078M Datasheet, PDF (6/8 Pages) Linear Technology – Micropower, Dual, Single Supply Precision Op Amp

RH1078M
TABLE 2: ELECTRICAL TEST REQUIRE E TS
MIL-STD-883 TEST REQUIREMENTS
Final Electrical Test Requirements (Method 5004)
Group A Test Requirements (Method 5005)
Group C and D End Point Electrical Parameters
(Method 5005)
* PDA Applies to subgroup 1. See PDA Test Notes.
SUBGROUP
1*,2,3,4,5,6
1,2,3,4,5,6
1,2,3
PDA Test Notes
The PDA is specified as 5% based on failures from group A, subgroup 1, tests
after cooldown as the final electrical test in accordance with method 5004 of
MIL-STD-883 Class B. The verified failures of group A, subgroup 1, after burn-
in divided by the total number of devices submitted for burn-in in that lot shall
be used to determine the percent for the lot.
Linear Technology Corporation reserves the right to test to tighter limits than
those given.
TYPICAL APPLICATIONS
Input Offset Voltage
1000
750
500
250
0
–250
–500
–750
–1000
1
10
100
TOTAL DOSE-KRADs (Si)
1000
1078M • G1
Input Bias Current
0
–20
–40
– 60
–80
–100
–120
–140
–160
1
10
100
TOTAL DOSE-KRADs (Si)
1000
1078M • G3
Input Offset Current
20
15
10
5
0
–5
–10
–15
–20
1
10
100
TOTAL DOSE-KRADs (Si)
1000
1078M • G2
Common-Mode Rejection Ratio
130
120
110
100
90
1
10
100
1000
TOTAL DOSE-KRADs (Si)
1078M • G4
6