LTC3525D-3.3_15 Datasheet, PDF (6/14 Pages) Linear Technology – 400mA Micropower Synchronous Step-Up DC/DC Converter with Pass Through Mode

LTC3525D-3.3
Pin Functions
SHDN (Pin 1): Logic-Controlled Shutdown Input. Connect
to a voltage >1V to enable the LTC3525D. Connect to a
voltage <0.4V to disable the LTC3525D and connect V_IN
to V_OUT through the inductor.
GND (Pins 2, 5): Ground.
V_IN (Pin 3): Input Voltage. The LTC3525D is powered from
V_IN until V_OUT exceeds V_IN. Once V_OUT is greater than
(V_IN + 0.2V typical), it is powered from V_OUT. Place a
ceramic bypass capacitor from V_IN to GND. A minimum
value of 1µF is recommended.
V_OUT (Pin 4): Output Voltage Sense and the Output of the
Synchronous Rectifier. Connect the output filter capacitor
from V_OUT to GND, close to the IC. A minimum value of
10µF ceramic is recommended. Use 22µF for reduced
output ripple. The pass-through mode feature connects
V_OUT to V_IN through the inductor when SHDN is <0.4V.
SW (Pin 6): Switch Pin. Connect an inductor from this
pin to V_IN. An internal antiringing resistor is connected
across SW and V_IN after the inductor current has dropped
to zero to minimize EMI.
3525d33fb
6
For more information www.linear.com/LTC3525D3.3