LT1033_02 Datasheet, PDF (6/12 Pages) Linear Technology – 3A Negative Adjustable Regulator

LT1033
APPLICATIONS INFORMATION
larger than 10µF may be used, but if the output is larger
than 25V, a diode, D2, should be added between the output
and adjustment pins (see Figure 2).
Proper Connection of Divider Resistors
The LT1033 has a load regulation specification of 0.8%
and is measured at a point 1/8" from the bottom of the
package. To prevent degradation of load regulation, the
resistors which set output voltage, R1 and R2, must be
connected as shown in Figure 3. Note that the positive side
of the load has a true force and sense (Kelvin) connection,
but the negative side of the load does not.
R1 should be connected directly to the output lead of the
regulator, as close as possible to the specified point 1/8"
from the case. R2 should be connected to the positive
side of the load separately from the positive (ground)
connection to the raw supply. With this arrangement, load
regulation is degraded only by the resistance between the
regulator output pin and the load. If R1 is connected to the
load, regulation will be degraded.
+
C1
R2
ADJ
–V_IN
V_IN
V_OUT
LT1033
R1
C3
D2**
1N4002
–V_OUT
D1* 1N4002
LT1033 • F02
*D1 PROTECTS THE REGULATOR FROM INPUT SHORTS TO GROUND. IT IS
REQUIRED ONLY WHEN C3 IS LARGER THAN 20µF AND V_OUT IS LARGER
THAN 6V
** D2 PROTECTS THE ADJUST PIN OF THE REGULATOR FROM OUTPUT
SHORTS IF C2 IS LARGER THAN 10µF AND V_OUT IS LARGER THAN –25V
Figure 2
LEAD RESISTANCE HERE DOES
NOT AFFECT LOAD REGULATION
R2
R1
ADJ
–V_IN
V_IN
V_OUT
LT1033
CONNECT R1
DIRECTLY TO
REGULATOR PIN
Figure 3
LOAD
LT1033 • F03
LEAD RESISTANCE HERE
DEGRADES LOAD
REGULATION. MINIMIZE
THE LENGTH OF THIS LEAD
1033fc
6