RH1814M_15 Datasheet, PDF (5/8 Pages) Linear Technology – Quad 3mA, 100MHz, 750V/s Operational Amplifier

RH1814M
TABLE 2: ELECTRICAL CHARACTERISTICS (Post-Irradiation)
V_S = 5V, OV, V_CM = 2.5V, T_A = 25°C, unless otherwise noted.
SYMBOL PARAMETER
CONDITIONS
10KRAD(Si) 20KRAD(Si) 50KRAD(Si) 100KRAD(Si) 200KRAD(Si)
MIN MAX MIN MAX MIN MAX MIN MAX MIN MAX UNITS
V_OS
Input Offset Voltage
(Note 4)
I_OS
Input Offset Current
I_B
Input Bias Current
Input Voltage Range
Negative
Positive
Guaranteed by CMRR
2.5
2.5
4.5
4.5
4.5 mV
500
500
750
1000
1500 nA
±5
±5
±7.5
±10
±15 µA
1.5
1.5
1.5
1.5
1.5
V
3.5
3.5
3.5
3.5
3.5
V
CMRR Common Mode Rejection V_CM = 1.5V to 3.5V
71
71
60
60
60
dB
Ratio
PSRR Power Supply Rejection V_S = ±2V to ±5.5V
77
75
65
65
65
dB
Ratio
A_VOL
Large-Signal Voltage Gain V_O = 1.5V to 3.5V, R_L = 500Ω 0.9
0.8
0.6
0.5
0.4
V_O = 1.5V to 3.5V, R_L = 100Ω 0.6
0.55
0.45
0.40
0.35
V/mV
V/mV
V_OUT
Maximum Output Voltage R_L = 500Ω, 30mV Overdrive 3.9
3.9
3.8
3.7
3.6
V
Swing (Positive)
R_L = 100Ω, 30mV Overdrive 3.7
3.65
3.55
3.45
3.40
V
Maximum Output Voltage R_L = 500Ω, 30mV Overdrive
Swing (Negative)
R_L = 100Ω, 30mV Overdrive
1.1
1.1
1.15
1.2
1.3
V
1.3
1.35
1.4
1.45
1.5
V
I_S
Supply Current
per Amplifier
4
4
4
4
4
mA
Note 1: Stresses beyond those listed under Absolute Maximum Ratings
may cause permanent damage to the device. Exposure to any Absolute
Maximum Rating condition for extended periods may affect device
reliability and lifetime.
Note 2: Differential inputs of ±6V are appropriate for transient operation
only, such as during slewing. Large sustained differential inputs can cause
excessive power dissipation and may damage the part.
Note 3: A heat sink may be required to keep the junction temperature
below absolute maximum when the output is shorted indefinitely.
Note 4: Input offset voltage is pulse tested and is exclusive of warm-up
drift.
Note 5: This parameter is not 100% tested.
1814mfb
5