LT1032_15 Datasheet, PDF (5/12 Pages) Linear Technology – Quad Low Power Line Driver

LT1032
TYPICAL PERFOR A CE CHARACTERISTICS
Output Waveform
50V
V_OUT
0
– 5V
R_L = 3k
C_L = 51pF
V_S = ±12V
V_OUT
10V
0
– 10V
LOGIC 5V
INPUT
0
0
2µs 4µs 6µs 8µs 10µs
LT1032 • TPC14
Output Waveform Driving
Capacitive Load
6V
4V
2V
V_OUT
0
R_L = 3.3k
V_S = ±6V
C_L = 0.01µF
– 2V
– 4V
– 6V
LOGIC
INPUT
5V
0
0
10µs
20µs
30µs
40µs 50µs
LT1032 • TPC16
Output Waveform
4V
2V
V_OUT
0
– 2V
– 4V
R_L = 450Ω
V_S = ±5V
C_L = 51pF
LOGIC
INPUT
5V
0
0
4µs 8µs 12µs 16µs 20µs
LT1032 • TPC15
Strobe Pin Response
OUTPUT
5V/DIV
0
V_IN = 0V
STROBE 5V
INPUT 0
0
R_L = 3k
V_S = ±12V
C_L = 51pF
2µs 4µs 6µs 8µs
LT1032 • TPC17
PI FU CTI S
V_EE (J, N & S: Pin 1): Minus Supply. Operates –2V to –15V.
(J & N: Pins 2, 5, 9, 12/S: Pins 2, 5, 11, 14): Logic
Input. Operates properly on TTL or CMOS levels. Output
valid form (V ^– + 2V) ≤ V_IN ≤ 15V. Connect to ground
when not used.
(J & N: Pins 3, 6, 8, 11/S: Pins 3, 6, 10, 13): Output. Line
drive output.
ON/OFF (J, N & S: Pin 4): Shuts down entire circuit.
Cannot be left open. For “normally on” operation, connect
to V ⁺.
GND (J, N & S: Pin 7): Ground. Ground must be more
positive than V^–.
Response Control (J & N: Pin 10/S: Pin 12): Allows
limited change of slew rate. Leave open when not used.
Strobe (J & N: Pin 13/ S: Pin 15): Forces all outputs low.
Drive with 3V.
V_CC (J & N:Pin 14/S: Pin 15): Positive Supply. Operates 5V
to 15V.
1032fe
5