RH6200M_15 Datasheet, PDF (4/10 Pages) Linear Technology – Low Noise, High Speed Rail-to-Rail Op Amp

RH6200M
TABLE 2: ELECTRICAL TEST
REQUIREMENTS
MIL-STD-883 TEST REQUIREMENTS
Final Electrical Test Requirements (Method 5004)
Group A Test Requirements (Method 5005)
Group B and D for Class S,
End Point Electrical Parameters (Method 5005)
*PDA applies to subgroup 1. See PDA Test Notes.
SUBGROUP
1*, 2, 3, 4, 5, 6
1*, 2, 3, 4, 5, 6
1, 2, 3
PDA Test Notes
The PDA is specified as 5% based on failures from group A, subgroup 1, tests
after cooldown as the final electrical test in accordance with method 5004
of MIL-STD-883. The verified failures of group A, subgroup 1, after burn-in
divided by the total number of devices submitted for burn-in in that lot shall
be used to determine the percent for the lot.
Linear Technology Corporation reserves the right to test to tighter limits
than those given.
TOTAL DOSE BIAS CIRCUIT
C_F*
10k
5V
–
10k ₊
–5V
RH6200 F02
*C_F IS COMPONENT OR PARASITIC
CAPACITANCE ENSURING STABILITY
TYPICAL PERFORMANCE CHARACTERISTICS
V_OS Distribution, V_CM = V⁺
80
V_S = 5V, 0V
70
60
50
40
30
20
10
0
–1600–1200 –800 –400 0 400 800 1200 1600
INPUT OFFSET VOLTAGE (μV)
RH6200 G01
V_OS Distribution, V_CM = V^–
80
V_S = 5V, 0V
70
60
50
40
30
20
10
0
–1600–1200 –800 –400 0 400 800 1200 1600
INPUT OFFSET VOLTAGE (μV)
RH6200 G02
Supply Current vs Supply Voltage
30
T_A = 125°C
25
20
T_A = 25°C
15
T_A = –55°C
10
5
0
02
4 6 8 10 12 14
TOTAL SUPPLY VOLTAGE (V)
RH6200 G03
4
rh6200mfa