RH1185AMK Datasheet, PDF (4/6 Pages) Linear Technology – Negative Regulator with Adjustable Current Limit

RH1185AMK
TABLE 2: POST BURN-IN ENDPOINTS AND DELTA LIMITS
REQUIREMENTS T_A = 25°C
PARAMETER AND
CONDITIONS
Reference Voltage, V_REF
V_IN = 7.4V, V_OUT = V_REF
ENDPOINT LIMITS
MIN MAX
2.346 2.394
DELTA LIMITS
MIN MAX
–0.040 0.040
UNITS
V
TABLE 3: ELECTRICAL TEST REQUIREMENTS
MIL-STD-883 TEST REQUIREMENTS
Final Electrical Test Requirements (Method 5004)
Group A Test Requirements (Method 5005)
Group B and D for Class S,
End Point Electrical Parameters (Method 5005)
*PDA applies to subgroup 1. See PDA Test Notes.
SUBGROUP
1*, 2, 3
1, 2, 3
1, 2, 3
PDA Test Notes
The PDA is specified as 5% based on failures from Group A, Subgroup 1,
tests after cooldown as the final electrical test in accordance with method
5004 of MIL-STD-883. The verified failures of Group A, Subgroup 1, after
burn-in divided by the total number of devices submitted for burn-in in that
lot shall be used to determine the percent for the lot.
Linear Technology Corporation reserves the right to test to tighter limits
than those given.
TOTAL DOSE BIAS CIRCUIT
15V
5k
3
1
REF
4k
2
GND
FB
4k
V_OUT ⁴
OUT
RH1185AMK DOSE
CASE
IN
–15V
4
rh1185amkfa