RH1086M_1 Datasheet, PDF (4/6 Pages) Linear Technology – 0.5A and 1.5A Low Dropout Positive Adjustable Regulators

RH1086M
TABLE 2: ELECTRICAL TEST REQUIREMENTS
MIL-STD-883 TEST REQUIREMENTS
Final Electrical Test Requirements (Method 5004)
Group A Test Requirements (Method 5005)
Group C and D End Point Electrical Parameters
(Method 5005)
*PDA applies to subgroup 1. See PDA Test Notes.
SUBGROUP
1*,2,3,4,5,6
1,2,3,4,5,6
1
PDA Test Notes
The PDA is specified as 5% based on failures from group A, subgroup 1,
tests after cooldown as the final electrical test in accordance with method
5004 of MIL-STD-883 Class B. The verified failures of group A, subgroup 1,
after burn-in divided by the total number of devices submitted for burn-in
in that lot shall be used to determine the percent for the lot.
Linear Technology Corporation reserves the right to test to tighter limits
than those given.
TOTAL DOSE BIAS CIRCUIT
15V
V_IN
RH1086M V_OUT
ADJ
150Ω
–15V RH1086 TA01
4
rh1086mfc