|
LTC3539 Datasheet, PDF (3/12 Pages) Linear Technology – 2A, 1MHz/2MHz Synchronous Step-Up DC/DC Converters | |||
|
◁ |
LTC3539/LTC3539-2
ELECTRICAL CHARACTERISTICS The l denotes the speciï¬cations which apply over the speciï¬ed
temperature range of â40°C to 85°C, otherwise speciï¬cations are at TA = 25°C. VIN = 1.2V, VOUT = 3.3V, unless otherwise noted.
PARAMETER
Maximum Duty Cycle
Minimum Duty Cycle
Switching Frequency
MODE Input High Voltage
CONDITIONS
VFB = 1.15V
VFB = 1.3V
LTC3539
LTC3539-2
MIN TYP MAX UNITS
l 87
90
%
l
0
%
l 0.7
1
1.3
MHz
l 1.8
2
2.4
MHz
0.88
V
MODE Input Low Voltage
0.3
V
MODE Input Current
SHDN Input High Voltage
SHDN Input Low Voltage
SHDN Input Current
VMODE = 1.2V
VSHDN = 1.2V
VSHDN = 3.3V
0.3
1
μA
0.88
V
0.3
V
0.3
1
μA
1
2
μA
Note 1: Stresses beyond those listed under Absolute Maximum Ratings
may cause permanent damage to the device. Exposure to any Absolute
Maximum Rating condition for extended periods may affect device
reliability and lifetime.
Note 2: The LTC3539E/LTC3539E-2 is guaranteed to meet performance
speciï¬cations from 0°C to 85°C. Speciï¬cations over â40°C to 85°C
operating temperature range are assured by design, characterization and
correlation with statistical process controls.
Note 3: Speciï¬cation is guaranteed by design and not 100% tested in
production.
Note 4: Current measurements are made when the output is not switching.
Note 5: This IC includes overtemperature protection that is intended
to protect the device during momentary overload conditions. Junction
temperature will exceed 125°C when overtemperature protection is active.
Continuous operation above the speciï¬ed maximum operating junction
temperature may result in device degradation or failure.
Note 6: Failure to solder the exposed backside of the package to the PC
board ground plane will result in a thermal resistance much higher than
60°C/W.
3539f
3
|
▷ |