|
RH137_15 Datasheet, PDF (2/2 Pages) Linear Technology – Negative Adjustable Regulator | |||
|
◁ |
DICE/DWF SPECIFICATION
RH137
Rad Hard die require special handling as compared to standard IC
chips.
Rad Hard die are susceptible to surface damage because there is no
silicon nitride passivation as on standard die. Silicon nitride protects
the die surface from scratches by its hard and dense properties. The
passivation on Rad Hard die is silicon dioxide that is much âsofterâ
than silicon nitride.
LTC recommends that die handling be performed with extreme care so
as to protect the die surface from scratches. If the need arises to move
the die around from the chip tray, use a Teï¬on-tipped vacuum wand.
This wand can be made by pushing a small diameter Teï¬on tubing
onto the tip of a steel-tipped wand. The inside diameter of the Teï¬on
tip should match the die size for efï¬cient pickup. The tip of the Teï¬on
should be cut square and ï¬at to ensure good vacuum to die surface.
Ensure the Teï¬on tip remains clean from debris by inspecting under
stereoscope.
During die attach, care must be exercised to ensure no tweezers touch
the top of the die.
Wafer level testing is performed per the indicated speciï¬cations for dice. Considerable differences in performance can often be observed for dice versus
packaged units due to the inï¬uences of packaging and assembly on certain devices and/or parameters. Please consult factory for more information
on dice performance and lot qualiï¬cations via lot sampling test procedures.
Dice data sheet subject to change. Please consult factory for current revision in production.
I.D.No. 66-13-0136
2
Linear Technology Corporation
1630 McCarthy Blvd., Milpitas, CA 95035-7417
(408) 432-1900 â FAX: (408) 434-0507 â www.linear.com
LT 1111 REV B ⢠PRINTED IN USA
© LINEAR TECHNOLOGY CORPORATION 1998
|