RH1078M_12 Datasheet, PDF (2/2 Pages) Linear Technology – RH1078M Micropower, Dual, Single-Supply Precision Op Amp

DICE SPECIFICATION
RH1078M
DICE ELECTRICAL TEST LIMITS T_A = 25°C, V_S = 5V, V_CM = 0.1V, V_OUT = 1.4V, unless otherwise specified.
SYMBOL
A_VOL
PARAMETER
Large-Signal Voltage Gain
V_OUT
Output Voltage Swing
SR
Slew Rate
I_S
Supply Current
Minimum Supply Voltage
CONDITIONS
V_O = 0.03V to 4V, No Load
V_O = 0.03V to 3.5V, R_L = 50k
V_O = 0.05V to 4V, No Load
V_O = 0.05V to 3.5V, R_L = 50k
Output Low, No Load
Output Low, 2k to GND
Output Low, I_SINK = 100μA
Output High, No Load
Output High, 2k to GND
A_V = 1, V_S = ±2.5V
Per Amplifier
Note 2
MIN
MAX UNITS
150
V/mV
120
V/mV
V/mV
V/mV
6
mV
2
mV
130
mV
4.2
V
3.5
V
0.04
75
V/μs
2.3
μA
350
V
T_A = 25°C, V_S = ±15V, unless otherwise specified.
SYMBOL
V_OS
I_OS
I_B
CMRR
PSRR
A_VOL
V_OUT
SR
I_S
PARAMETER
Input Offset Voltage
Input Offset Current
Input Bias Current
Input Voltage Range
Common Mode Rejection Ratio
Power Supply Rejection Ratio
Large-Signal Voltage Gain
Output Voltage Swing
Slew Rate
Supply Current
CONDITIONS
V_CM = 13.5V, –15V
V_CM = 13V, –14.9V
V_S = 5V, 0V to ±18V
V_O = ±10V, R_L = 50k
V_O = ±10V, R_L = 2k
V_O = ±10V, R_L = 5k
RL = 50k
RL = 2k
RL = 5k
Per Amplifier
MIN
13.5
–15.0
97
100
1000
300
±13
±11
0.06
MAX UNITS
350
μV
0.8
nA
15
nA
V
V
dB
dB
dB
V/mV
V/mV
V/mV
V
V
V
V/μs
100
μA
Note 1: Stresses beyond those listed under Absolute Maximum Ratings
may cause permanent damage to the device. Exposure to any Absolute
Maximum Rating condition for extended periods may affect device
reliability and lifetime.
Note 2: Power supply rejection ratio is measured at the minimum supply
voltage.
Wafer level testing is performed per the indicated specifications for dice. Considerable differences in performance can often be observed for dice versus
packaged units due to the influences of packaging and assembly on certain devices and/or parameters. Please consult factory for more information
on dice performance and lot qualifications via lot sampling test procedures.
Dice data sheet subject to change. Please consult factory for current revision in production.
I.D.No. 66-13-1078
2
Linear Technology Corporation
1630 McCarthy Blvd., Milpitas, CA 95035-7417
[phone] ^● FAX: [phone] ^● www.linear.com
LT 0912 REV A • PRINTED IN USA
LINEAR TECHNOLOGY CORPORATION 2005