RH1009 Datasheet, PDF (2/2 Pages) Linear Technology – 2.5V Reference

RH1009
TABLE 1A: ELECTRICAL CHARACTERISTICS (Postirradiation) (Note 2)
SYMBOL PARAMETER
CONDITIONS
10KRAD(Si) 20KRAD(Si) 50KRAD(Si) 100KRAD(Si) 200KRAD(Si)
NOTES MIN MAX MIN MAX MIN MAX MIN MAX MIN MAX UNITS
V_Z
Reverse Breakdown
Voltage
I_R = 1mA
2.495 2.505 2.495 2.505 2.495 2.505 2.495 2.505 2.495 2.505 V
∆V_Z Reverse Breakdown Voltage 400µA ≤ I_R ≤ 10mA
∆I_Z Change with Current
r_Z
Reverse Dynamic
I_R = 1mA
1
Impedance
6
6
8
10
12 mV
0.6
0.6
0.8
1.0
1.4
Ω
Note 1: Guaranteed by design, characterization or correlation to other
tested parameters.
Note 2: T_A = 25°C unless otherwise noted.
TOTAL DOSE BIAS CIRCUIT
15V
12.4k
RH1009 TDBC
TABLE 2: ELECTRICAL TEST REQUIRE E TS
MIL-STD-883 TEST REQUIREMENTS
Final Electrical Test Requirements (Method 5004)
Group A Test Requirements (Method 5005)
Group C and D End Point Electrical Parameters
(Method 5005)
* PDA Applies to subgroup 1. See PDA Test Notes.
SUBGROUP
1*,2,3
1,2,3
1
PDA Test Notes
The PDA is specified as 5% based on failures from group A, subgroup 1,
tests after cooldown as the final electrical test in accordance with method
5004 of MIL-STD-883 Class B. The verified failures of group A, subgroup
1, after burn-in divided by the total number of devices submitted for burn-
in in that lot shall be used to determine the percent for the lot.
Linear Technology Corporation reserves the right to test to tighter limits
than those given.
TYPICAL PERFORMANCE CHARACTERISTICS
Reverse Breakdown Voltage
2.502
I_R = 1mA
2.501
Reverse Breakdown Voltage
Change with Current
0
600µA ≤ I_R ≤ 10mA
–2
–4
–6
2.500
–8
–10
2.499
–12
2.498
1
10
100
TOTAL DOSE KRAD (Si)
1000
RH1009 G01
2
Linear Technology Corporation
1630 McCarthy Blvd., Milpitas, CA 95035-7417 ^q [phone]
FAX: [phone]^q TELEX: 499-3977 ^q www.linear-tech.com
–14
1
10
100
TOTAL DOSE KRAD (Si)
1000
RH1009 G02
I.D. No. 66-10-0174 Rev. B 0497
LT/HP 0497 500 REV B • PRINTED IN USA
© LINEAR TECHNOLOGY CORPORATION 1990