English
Language : 

LTC3212 Datasheet, PDF (2/12 Pages) Linear Technology – RGB LED Driver and Charge Pump
LTC3212
Absolute Maximum Ratings
(Note 1)
VIN to GND.................................................... –0.3V to 6V
CPO to GND.................................................. –0.3V to 6V
LEDEN ............................................. –0.3V to VIN + 0.3V
ICPO (Note 2)...........................................................75mA
ILED(R,G,B) (Note 2)..................................................30mA
CPO Short-Circuit Duration.............................. Indefinite
Operating Temperature Range
(Notes 3, 4).......................................... –40°C to 85°C
Storage Temperature Range................... –65°C to 125°C
pIN CONFIGURATION
TOP VIEW
CP 1
CPO 2
LEDEN 3
ISETB 4
ISETR 5
ISETG 6
12 VIN
11 CM
10 GND
13
9 LEDB
8 LEDR
7 LEDG
DDB PACKAGE
12-LEAD (3mm × 2mm) PLASTIC DFN
TJMAX = 125°C, θJA = 76°C/W
EXPOSED PAD (PIN 13) IS GND, MUST BE SOLDERED TO PCB
order information
LEAD FREE FINISH
TAPE AND REEL
PART MARKING
PACKAGE DESCRIPTION
LTC3212EDDB#PBF
LTC3212EDDB#TR
LCWM
12-Lead (3mm × 2mm) Plastic DFN
Consult LTC Marketing for parts specified with wider operating temperature ranges.
Consult LTC Marketing for information on non-standard lead based finish parts.
For more information on lead free part marking, go to: http://www.linear.com/leadfree/
For more information on tape and reel specifications, go to: http://www.linear.com/tapeandreel/
TEMPERATURE RANGE
–40°C to 85°C
Electrical Characteristics The ● denotes the specifications which apply over the full operating
temperature range, otherwise specifications are at TA = 25°C. VIN = 3.6V.
PARAMETER
CONDITIONS
MIN TYP MAX UNITS
VIN Operating Voltage
IVIN Operating Current
VIN Shutdown Current
LED Current
ICPO = 0mA, 1x Mode
ICPO = 0mA, 2x Mode
LEDEN = Low
● 2.7
5.5
V
0.4
mA
2.0
mA
3
8
µA
Current Ratio (ILEDG/ISETG)
Current Ratio (ILEDB/ISETB)
Current Ratio (ILEDB/ISETG)
Current Ratio (ILEDR/ISETR)
Current Ratio (ILEDR/ISETG)
ILED Dropout Voltage (VILED)
tEN
Mode Switching Delay
ISETG = 78µA
173
192
210
A/A
ISETB = 78µA
173
192
210
A/A
White Mode, ISETG = 78µA
128
144
160
A/A
ISETR = 78µA
173
192
210
A/A
White Mode, ISETG = 78µA
154
171
186
A/A
Mode Switching Theshold, ILED = 15mA
150
mV
Current Source Enable Time (LEDEN = High) (Note 5) l
400
µs
50
120
250
µs
Charge Pump (CPO)
Charge Pump Output Voltage Clamp
5.1
V
1x Mode Output Impedance
(Notes 6, 7)
5
Ω
3212fb