English
Language : 

LTC3525-3.3 Datasheet, PDF (10/12 Pages) Linear Technology – 400mA Micropower Synchronous Step-Up DC/DC Converter with Output Disconnect
LTC3525-3.3/LTC3525-5
U
OPERATIO
Component Selection
Inductor values between 4.7µH and 15µH are recom-
mended. In most applications 10µH will yield the best
compromise between size and efficiency. The inductor
should be a low-loss ferrite design and must be rated for
peak currents of at least 400mA without saturating. Induc-
tors with lower DC resistance will improve efficiency. Note
that the inductor value does not have a significant effect on
ripple current, so while lower values will increase the
operating frequency, they do not reduce output voltage
ripple.
Some recommended inductor examples are Murata
LQH32C and Coilcraft LPO4812, LPO3310, DO3314,
DS1608 and MSS4020.
A ceramic input bypass capacitor should be located as
close as possible to the VIN and GND pins of the IC. A
minimum value of 1µF is recommended. If the battery is
more than a few inches away, a bulk tantalum decoupling
cap of at least 10µF is recommended on VIN.
The output capacitor should also be a ceramic, located
close to the VOUT and GND pins. A minimum value of 10µF
is recommended. Increasing the value of the output ca-
pacitor to 22µF will result in lower output ripple. Higher
capacitor values will only offer a small reduction in output
ripple, while reducing light load efficiency by causing the
peak inductor current to increase above its minimum value
of 150mA. The input and output capacitors should be X5R
or X7R types, not Y5V.
Table 1. Inductor Vendor Information
SUPPLIER
Murata
Coilcraft
Sumida
PHONE
USA: (814) 237-1431
(847) 639-6400
USA (847) 956-0666
Table 2. Capacitor Vendor Information
SUPPLIER
Murata
Taiyo Yuden
TDK
AVX
PHONE
USA: (814) 237-1431
(408) 573-4150
(847) 803-6100
(803) 448-9411
FAX
USA: (814) 238-0490
(847) 639-1469
USA (847) 956-0702
FAX
USA: (814) 238-0490
(408) 573-4159
(847) 803-6296
(803) 448-1943
WEBSITE
www.murata.com
www.coilcraft.com
www.sumida.com
WEBSITE
www.murata.com
www.t-yuden.com
www.component.tdk.com
www.avxcorp.com
SHDN
VIN
SHDN SW
LTC3525
GND GND
VIN
VOUT
3525 F02
VOUT
Figure 2. Recommended Component Placement
3525f
10