LT1809_15 Datasheet, PDF (10/24 Pages) Linear Technology – Single/Dual 180MHz, 350V/s Rail-to-Rail Input and Output Low Distortion Op Amps

LT1809/LT1810
ELECTRICAL CHARACTERISTICS
Note 1: Stresses beyond those listed under Absolute Maximum Ratings
may cause permanent damage to the device. Exposure to any Absolute
Maximum Rating condition for extended periods may affect device
reliability and lifetime.
Note 2: The inputs are protected by back-to-back diodes. If the differential
input voltage exceeds 1.4V, the input current should be limited to less than
10mA.
Note 3: A heat sink may be required to keep the junction temperature
below the absolute maximum rating when the output is shorted
indefinitely.
Note 4: The LT1809C/LT1809I and LT1810C/LT1810I are guaranteed
functional over the operating temperature range of – 40°C and 85°C.
Note 5: The LT1809C/LT1810C are guaranteed to meet specified
performance from 0°C to 70°C. The LT1809C/LT1810C are designed,
characterized and expected to meet specified performance from –40°C
to 85°C but are not tested or QA sampled at these temperatures. The
LT1809I/LT1810I are guaranteed to meet specified performance from
–40°C to 85°C.
Note 6: Minimum supply voltage is guaranteed by power supply rejection
ratio test.
Note 7: Output voltage swings are measured between the output and
power supply rails.
Note 8: This parameter is not 100% tested.
Note 9: Thermal resistance varies depending upon the amount of PC board
metal attached to the V^– pin of the device. θ_JA is specified for a certain
amount of 2oz of copper metal trace connecting to the V^– pin as described
in the thermal resistance tables in the Applications Information section.
Note 10: Matching parameters are the difference between the two
amplifiers of the LT1810.
10
180910fa