English
Language : 

LTC3704 Datasheet, PDF (1/28 Pages) Linear Technology – Wide Input Range, No RSENSE Positive-to-Negative DC/DC Controller
LTC3704
Wide Input Range, No RSENSETM
Positive-to-Negative DC/DC Controller
FEATURES
DESCRIPTIO
s High Efficiency Operation (No Sense
Resistor Required)
s Wide Input Voltage Range: 2.5V to 36V
s Current Mode Control Provides Excellent Transient
Response
s High Maximum Duty Cycle (Typ 92%)
s ±1% Internal Voltage Reference
s ±2% RUN Pin Threshold with 100mV Hysteresis
s Micropower Shutdown: IQ = 10µA
s Programmable Switching Frequency
(50kHz to 1MHz) with One External Resistor
s Synchronizable to an External Clock Up to 1.3 × fOSC
s User-Controlled Pulse Skip or Burst Mode® Operation
s Internal 5.2V Low Dropout Voltage Regulator
s Capable of Operating with a Sense Resistor for High
Output Voltage Applications (VDS >36V)
s Small 10-Lead MSOP Package
U
APPLICATIO S
s SLIC Power Supplies
s Telecom Power Supplies
s Portable Electronic Equipment
s Cable and DSL Modems
s Router Supplies
The LTC®3704 is a wide input range, current mode,
positive-to-negative DC/DC controller that drives an
N-channel power MOSFET and requires very few external
components. Intended for low to high power applications,
it eliminates the need for a current sense resistor by
utilizing the power MOSFET’s on-resistance, thereby maxi-
mizing efficiency.
The IC’s operating frequency can be set with an external
resistor over a 50kHz to 1MHz range, and can be synchro-
nized to an external clock using the MODE/SYNC pin.
Burst Mode operation at light loads, a low minimum
operating supply voltage of 2.5V and a low shutdown
quiescent current of 10µA make the LTC3704 ideally
suited for battery-operated systems.
For applications requiring constant frequency operation,
the Burst Mode operation feature can be defeated using
the MODE/SYNC pin. Higher than 36V switch voltage
applications are possible with the LTC3704 by connecting
the SENSE pin to a resistor in the source of the power
MOSFET.
The LTC3704 is available in the 10-lead MSOP package.
, LTC and LT are registered trademarks of Linear Technology Corporation.
Burst Mode is a registered trademark of Linear Technology Corporation.
No RSENSE is a trademark of Linear Technology Corporation.
TYPICAL APPLICATIO
RC
3k
CC1
4.7nF
R1
1M
1
RUN
2
ITH
10
SENSE
9
VIN
LTC3704
3
8
NFB
INTVCC
4
7
FREQ
GATE
5
6
MODE/SYNC GND
RT
80.6k
1%
RFB1
1.21k
1%
RFB2
3.65k
1%
CVCC
4.7µF
•
L1*
•
CDC
L2*
47µF
M1
D1
CIN
47µF
VIN
5V to 15V
VOUT
–5.0V
3A to 5A
COUT
100µF
(X2)
GND
3704 TA01
CIN, CDC : TDK C5750X5R1C476M
COUT: TDK C5750X5R0J107M
CVCC: TAIYO YUDEN LMK316BJ475ML
D1: MBRD835L (ON SEMICONDUCTOR)
L1, L2: BH ELECTRONICS BH510-1009
M1: Si4884 (SILICONIX/VISHAY)
Figure 1. High Efficiency Positive to Negative Supply
Conversion Efficiency
100
90
80
VIN = 5V
70
VIN = 15V
60
VIN = 10V
50
40
30
20
0.001
0.01
0.1
1.0
10
OUTPUT CURRENT (A)
3704 TA01b
sn3704 3704fs
1