LTC2937 Datasheet, PDF (1/24 Pages) Linear Technology – Programmable Six Channel Sequencer and Voltage Supervisor with EEPROM

DEMO MANUAL DC2313A
Programmable
Six Channel Sequencer and
Voltage Supervisor with EEPROM
Description
Demonstration circuit 2313A showcases the LTC2937, a
programmable six channel power supply sequencer and
voltage supervisor.
The LTC2937 provides flexible sequence control for up
to six power supplies. It enables and disables the sup-
plies with configurable sequence order and time delays,
monitors the supplies for power-up and power-down time,
and for overvoltage and undervoltage. It cooperates with
other LTC2937 parts in the system to coordinate power
sequencing activities. It provides flexible fault response to
autonomously supervise the power supplies, and powerful
debug tools to diagnose any problem that causes a power-
supply fault. It holds configuration in non-volatile EEPROM
for completely automatic power system supervision.
The DC2313A board demonstrates the powerful features
of the LTC2937 using six onboard LDO voltage regula-
tors, or by controlling an optional, externally-powered
DC1361 board (an 8-channel power supply board). Multiple
DC2313A boards can also share timing and sequencing
signals to supervise more than six regulated supplies in
a coordinated manner.
The DC2313A connects to a PC through the DC1613 USB-
to-I²C/SMBus/PMBus Controller. This connection enables
the LTpowerPlay™ software, to have complete control over
the LTC2937 through the convenient LTpowerPlay GUI.
The GUI allows control over all of the LTC2937 registers,
and visibility into the status of the part in real time, and
it works with Linear Technology demo boards as well as
custom boards with an I²C interface.
Design files for this circuit board are available at
http://www.linear.com/demo/DC2313A
L, LT, LTC, LTM, Linear Technology and the Linear logo are registered trademarks and
LTpowerPlay is a trademark of Linear Technology Corporation. All other trademarks are the
property of their respective owners.
Performance Summary
PARAMETER
CONDITIONS
MIN TYP MAX
UNITS
V_IN Voltage Range
I_IN Current to the Board
I_IN Current
V1-V6 Voltage Range
All
Sequenced-Down
Sequenced-Up, No Loads
Volts at the Turret
6
12
14
V
3.8
mA
17.5
mA
0
6
V
EN1-EN6 Voltage Range
Volts at the Turret^†
0
6
V
Regulated LDO Voltage Tolerance
Load Current < 20mA
–1
1
%
Rated Output Current *V_OUT pins
Load Current Per Channel
20
mA
Board Operating Temperature
Powered
0
60
°C
Serial Clock Frequency
I²C Bus Operating
10
400
kHz
†_{NOTE: Analog switches U7, U8, and U9 (LTC222) are powered by 5V, and limit the maximum voltage range allowed at their S and D pins. The LTC2937}
can tolerate up to 16.5V on its ENn pins.
dc2313af
1