LTC1871 Datasheet, PDF (1/36 Pages) Linear Technology – Wide Input Range, No RSENSE Current Mode Boost, Flyback and SEPIC Controller

LTC1871
Wide Input Range, No R_SENSE^TM
Current Mode Boost, Flyback and SEPIC Controller
FEATURES
s _{High Efficiency (No Sense Resistor Required)}
s _{Wide Input Voltage Range: 2.5V to 36V}
s _{Current Mode Control Provides Excellent}
Transient Response
s _{High Maximum Duty Cycle (92% Typ)}
s _{±2% RUN Pin Threshold with 100mV Hysteresis}
s _{±1% Internal Voltage Reference}
s _{Micropower Shutdown: IQ = 10µA}
s _{Programmable Operating Frequency}
(50kHz to 1MHz) with One External Resistor
s _{Synchronizable to an External Clock Up to 1.3 × fOSC}
s _{User-Controlled Pulse Skip or Burst Mode}^® _Operation
s _{Internal 5.2V Low Dropout Voltage Regulator}
s _{Output Overvoltage Protection}
s _{Capable of Operating with a Sense Resistor for High}
Output Voltage Applications
s _{Small 10-Lead MSOP Package}
U
APPLICATIO S
s _{Telecom Power Supplies}
s _{Portable Electronic Equipment}
DESCRIPTIO
The LTC^®1871 is a wide input range, current mode, boost,
flyback and SEPIC controller that drives an N-channel
power MOSFET and requires very few external compo-
nents. Intended for low to medium power applications, it
eliminates the need for a current sense resistor by utiliz-
ing the power MOSFET’s on-resistance, thereby maximiz-
ing efficiency.
The IC’s operating frequency can be set with an external
resistor over a 50kHz to 1MHz range, and can be synchro-
nized to an external clock using the MODE/SYNC pin.
Burst Mode operation at light loads, a low minimum
operating supply voltage of 2.5V and a low shutdown
quiescent current of 10µA make the LTC1871 ideally
suited for battery-operated systems.
For applications requiring constant frequency operation,
Burst Mode operation can be defeated using the MODE/
SYNC pin. Higher output voltage boost, SEPIC and fly-
back applications are possible with the LTC1871 by
connecting the SENSE pin to a resistor in the source of the
power MOSFET.
The LTC1871 is available in the 10-lead MSOP package.
, LTC and LT are registered trademarks of Linear Technology Corporation.
Burst Mode is a registered trademark of Linear Technology Corporation.
No R_SENSE is a trademark of Linear Technology Corporation.
TYPICAL APPLICATIO
V_IN
3.3V
L1
1µH
D1
R_C
22k
C_C1
6.8nF
C_C2
47pF
R2
37.4k
1%
R1
12.1k
1%
R_T
80.6k
1%
RUN
SENSE
I_TH
V_IN
LTC1871
FB
FREQ
INTV_CC
GATE
MODE/SYNC GND
M1
C_{VCC +}
4.7µF
X5R
C_IN
22µF
6.3V
×2
C_IN: TAIYO YUDEN JMK325BJ226MM
C_OUT1: PANASONIC EEFUEOJ151R
C_OUT2: TAIYO YUDEN JMK325BJ226MM
D1: MBRB2515L
L1: SUMIDA CEP125-H 1R0MH
M1: FAIRCHILD FDS7760A
V_OUT
5V
+ ^COUT1
150µF
7A
(10A PEAK)
6.3V
×4
C_OUT2
22µF
6.3V
X5R
×2
GND
1871 F01a
Figure 1. High Efficiency 3.3V Input, 5V Output Boost Converter (Bootstrapped)
Efficiency of Figure 1
100
90
Burst Mode
80
OPERATION
70
PULSE-SKIP
60
MODE
50
40
30
0.001
0.01
0.1
1
OUTPUT CURRENT (A)
10
1871 F01b
1