LTC1152 Datasheet, PDF (1/8 Pages) Linear Technology – Rail-to-Rail Input Rail-to-Rail Output Zero-Drift Op Amp

FEATURES
s _{Input Common-Mode Range Includes Both Rails}
s _{Output Swings Rail to Rail}
s _{Output Will Drive 1kΩ Load}
s _{No External Components Required}
s _{Input Offset Voltage: 10µV Max}
s _{Input Offset Drift: 100nV/°C Max}
s _{Minimum CMRR: 115dB}
s _{Supply Current: 3.0mA Max}
s _{Shutdown Pin Drops Supply Current to 5µA Max}
s _{Output Configurable to Drive Any Capacitive Load}
s _{Operates from 2.7V to 14V Total Supply Voltage}
APPLICATI S
s _{Rail-to-Rail Amplifiers and Buffers}
s _{High Resolution Data Acquisition Systems}
s _{Supply Current Sensing in Either Rail}
s _{Low Supply Voltage Transducer Amplifiers}
s _{High Accuracy Instrumentation}
s _{Single Negative Supply Operation}
TYPICAL APPLICATI
Rail-to-Rail Buffer
5V
2^{– 7}
LTC1152
6
OUT
3+
IN
4
1152 TA01
LTC1152
Rail-to-Rail Input
Rail-to-Rail Output
Zero-Drift Op Amp
DESCRIPTIO
The LTC^®1152 is a high performance, low power zero-drift
op amp featuring an input stage that common modes to
both power supply rails and an output stage that provides
rail-to-rail swing, even into heavy loads. The wide input
common-mode range is achieved with a high frequency
on-board charge pump. This technique eliminates the
crossover distortion and limited CMRR imposed by com-
peting technologies. The LTC1152 is a C-Load^TM of amp,
enabling it to drive any capacitive load.
The LTC1152 shares the excellent DC performance specs
of LTC’s other zero-drift amplifiers. Typical offset voltage
is 1µV and typical offset drift is 10nV/°C. CMRR and PSRR
are 130dB and 120dB and open-loop gain is 130dB. Input
noise voltage is 2µV_P-P from 0.1Hz to 10Hz. Gain-band-
width product is 0.7MHz and slew rate is 0.5V/µs, all with
supply current of 3.0mA max over temperature. The
LTC1152 also includes a shutdown feature which drops
supply current to 1µA and puts the output stage in a high
impedance state.
The LTC1152 is available in 8-pin PDIP and 8-pin SO
packages and uses the standard op amp pinout, allowing
it to be a plug-in replacement for many standard op amps.
, LTC and LT are registered trademarks of Linear Technology Corporation.
C-Load is trademark of Linear Technology Corporation.
Input and Output Waveforms
5V
V_OUT
2V/DIV
0V
5V
V_IN
2V/DIV
0V
1152 TA02
1