LTC1096 Datasheet, PDF (1/28 Pages) Linear Technology – Micropower Sampling 8-Bit Serial I/O A/D Converters

LTC1096/LTC1096L
LTC1098/LTC1098L
Micropower Sampling
8-Bit Serial I/O A/D Converters
FEATURES
s _{80µA Maximum Supply Current}
s _{1nA Typical Supply Current in Shutdown}
s _{8-Pin SO Plastic Package}
s _{5V Operation (LTC1096/LTC1098)}
s _{3V Operation (LTC1096L/LTC1098L)(2.65V Min)}
s _{Sample-and-Hold}
s _{16µs Conversion Time}
s _{33kHz Sample Rate}
s _{±0.5LSB Total Unadjusted Error Over Temp}
s _{Direct 3-Wire Interface to Most MPU Serial Ports and}
All MPU Parallel I/O Ports
APPLICATI S
s _{Battery-Operated Systems}
s _{Remote Data Acquisition}
s _{Battery Monitoring}
s _{Battery Gas Gauges}
s _{Temperature Measurement}
s _{Isolated Data Acquisition}
, LTC and LT are registered trademarks of Linear Technology Corporation.
DESCRIPTIO
The LTC^®1096/LTC1096L/LTC1098/LTC1098L are
micropower, 8-bit A/D converters that draw only 80µA of
supply current when converting. They automatically power
down to 1nA typical supply current whenever they are not
performing conversions. They are packaged in 8-pin SO
packages and have both 3V (L) and 5V versions. These
8-bit, switched-capacitor, successive approximation ADCs
include sample-and-hold. The LTC1096/LTC1096L have a
single differential analog input. The LTC1098/LTC1098L
offer a software selectable 2-channel MUX.
On-chip serial ports allow efficient data transfer to a wide
range of microprocessors and microcontrollers over three
wires. This, coupled with micropower consumption, makes
remote location possible and facilitates transmitting data
through isolation barriers.
These circuits can be used in ratiometric applications or
with an external reference. The high impedance analog
inputs and the ability to operate with reduced spans
(below 1V full scale) allow direct connection to sensors
and transducers in many applications, eliminating the
need for gain stages.
TYPICAL APPLICATI
10µW, S8 Package, 8-Bit A/D
Samples at 200Hz and Runs Off a 5V Battery
1µF 5V
ANALOG INPUT
0V TO 5V RANGE
CS/
SHUTDOWN
V_CC
+IN
CLK
LTC1096
–IN
D_OUT
GND
V_REF
MPU
(e.g., 8051)
P1.4
P1.3
P1.2
LTC1096/8 • TA01
Supply Current vs Sample Rate
1000
T_A = 25°C
V_CC = V_REF = 5V
100
10
1
0.1
1
10
100
SAMPLE FREQUENCY, f_SMPL (kHz)
LTC1096/98 • TPC03
1