LT1213_1 Datasheet, PDF (1/20 Pages) Linear Integrated Systems – 28MHz, 12V/ms, Single Supply Dual and Quad Precision Op Amps

LT1213/LT1214
28MHz, 12V/µs, Single Supply
Dual and Quad
Precision Op Amps
FEATURES
s _{Slew Rate: 12V/µs Typ}
s _{Gain-Bandwidth Product: 28MHz Typ}
s _{Fast Settling to 0.01%}
2V Step to 200µV: 500ns Typ
10V Step to 1mV: 1.1µs Typ
s _{Excellent DC Precision in All Packages}
Input Offset Voltage: 275µV Max
Input Offset Voltage Drift: 6µV/°C Max
Input Offset Current: 40nA Max
Input Bias Current: 200nA Max
Open-Loop Gain: 1200V/mV Min
s _{Single Supply Operation}
Input Voltage Range Includes Ground
Output Swings to Ground While Sinking Current
s _{Low Input Noise Voltage: 10nV/√Hz Typ}
s _{Low Input Noise Current: 0.2pA/√Hz Typ}
s _{Specified at 3.3V, 5V and ±15V}
s _{Large Output Drive Current: 30mA Min}
s _{Low Supply Current per Amplifier: 3.5mA Max}
s _{Dual in 8-Pin DIP and SO-8}
s _{Quad in 14-Pin DIP and NARROW SO-16}
Note: For applications requiring higher slew rate, see the LT1215/LT1216
data sheet. For lower power and lower slew rate, see the LT1211/LT1212 data
sheet.
DESCRIPTIO
The LT^®1213 is a dual, single supply precision op amp with
a 28MHz gain-bandwidth product and a 12V/µs slew rate.
The LT1214 is a quad version of the same amplifier. The
DC precision of the LT1213/LT1214 eliminates trims in
most systems while providing high frequency perfor-
mance not usually found in single supply amplifiers.
The LT1213/LT1214 will operate on any supply greater
than 2.5V and less than 36V total. These amplifiers are
specified at single 3.3V, single 5V and ±15V supplies, and
only require 2.7mA of quiescent supply current per ampli-
fier. The inputs can be driven beyond the supplies without
damage or phase reversal of the output. The minimum
output drive is 30mA, ideal for driving low impedance
loads.
U
APPLICATIO S
s _{2.5V Full-Scale 12-Bit Systems: VOS ≤ 0.45LSB}
s _{10V Full-Scale 16-Bit Systems: VOS ≤ 1.8LSB}
s _{Active Filters}
s _{Photodiode Amplifiers}
s _{DAC Current-to-Voltage Amplifiers}
s _{Battery-Powered Systems}
, LTC and LT are registered trademarks of Linear Technology Corporation.
TYPICAL APPLICATIO
Single Supply 3-Pole 1MHz Butterworth Filter
R3
680Ω
V_IN
R2
680Ω
C3
390pF
C2
200pF
R1
680Ω
V⁺ _0.1µF
C1
150pF
+
1/2
LT1213
–
V_OUT
A_V = 2
MAXIMUM OUTPUT OFFSET = 714µV
4.12k
4.12k
5pF
1213/14 TA01
10
0
–10
–20
–30
–40
–50
–60
10k
Frequency Response
100k
1M
FREQUENCY (Hz)
10M
1213/14 TA02
1