JAW050A1 Datasheet, PDF (4/16 Pages) Lineage Power Corporation – JAW050A and JAW075A Power Modules; dc-dc Converters 36 Vdc to 75 Vdc Input, 5 Vdc Output; 50 W to 75 W

JAW050A and JAW075A Power Modules; dc-dc Converters:
36 Vdc to 75 Vdc Input, 5 Vdc Output; 50 W to 75 W
Data Sheet
April 2008
General Specifications
Parameter
Calculated MTBF (IO = 80% of IO, max; TC = 40 °C)
Weight
Min
Typ
Max
Unit
3,000,000
hours
—
—
100 (3.5) g (oz.)
Feature Specifications
Unless otherwise indicated, specifications apply over all operating input voltage, resistive load, and temperature
conditions. See the Feature Descriptions section for additional information.
Parameter
Remote On/Off Signal Interface
(VI = 0 V to 75 V; open collector or equivalent compatible;
signal referenced to VI(–) terminal):
JAWxxxA1 Preferred Logic:
Logic Low—Module On
Logic High—Module Off
JAWxxxA Optional Logic:
Logic Low—Module Off
Logic High—Module On
Logic Low:
At Ion/off = 1.0 mA
At Von/off = 0.0 V
Logic High:
At Ion/off = 0.0 µA
Leakage Current
Turn-on Time (See Figure 10.)
(IO = 80% of IO, max; VO within ±1% of steady state)
Output Voltage Adjustment:
Output Voltage Remote-sense Range
Output Voltage Set-point Adjustment Range (trim)
Output Overvoltage Protection
Overtemperature Protection
* These are manufacturing test limits. In some situations, results may differ.
Symbol Min Typ Max Unit
Von/off
0
— 1.2
V
Ion/off
—
— 1.0
mA
Von/off
—
—
15
V
Ion/off
—
—
50
µA
—
—
40
80
ms
—
—
VO, sd
TC
—
— 0.5
V
60
—
110 %VO, nom
5.9* — 7.0*
V
— 105 —
°C
Solder, Cleaning, and Drying Considerations
Post solder cleaning is usually the final circuit-board assembly process prior to the electrical board testing. The
result of inadequate circuit-board cleaning and drying can affect both the reliability of a power module and the test-
ability of the finished circuit-board assembly. For guidance on appropriate soldering, cleaning, and drying proce-
dures, refer to the Board-Mounted Power Modules: Soldering and Cleaning Application Note (AP97-021EPS).
4
Lineage Power