APTS030A0X Datasheet, PDF (4/23 Pages) Lineage Power Corporation – 12V Mega TLynxTM : Non-Isolated DC-DC Power Modules

Data Sheet
November 11, 2010
12V Mega TLynx^TM: Non-Isolated DC-DC Power Modules:
6.0 – 14Vdc Input; 0.8Vdc to 3.63Vdc Output; 30A output current
Feature Specifications
Unless otherwise indicated, specifications apply over all operating input voltage, resistive load, and temperature
conditions. See Feature Descriptions for additional information.
Parameter
Device Symbol Min Typ Max
Unit
On/Off Signal Interface
(VIN=VIN, min to VIN, max ; open collector or equivalent,
Signal referenced to GND)
Logic High (On/Off pin open – Module OFF)
Input High Current
Input High Voltage
Logic Low (Module ON)
Input Low Current
Input Low Voltage
Turn-On Delay and Rise Times
All
IIH
0.5
⎯
3.3
mA
All
VIH
3.0
⎯
VIN, max
V
All
IIL
⎯
⎯
200
µA
All
VIL
-0.3 ⎯
1.2
V
(VIN=VIN, nom, IO=IO, max , VO to within ±1% of steady state)
Case 1: On/Off input is enabled and then
input power is applied (delay from instant at
which VIN = VIN, min until Vo = 10% of Vo, set)
Case 2: Input power is applied for at least one second and
then the On/Off input is enabled (delay from instant at which
Von/Off is enabled until Vo = 10% of Vo, set)
All
Tdelay
―
2.5
5
msec
All
Tdelay
―
2.5
5
msec
Output voltage Rise time (time for Vo to rise from
10% of Vo, set to 90% of Vo, set)
All
Trise
2
10
msec
Output voltage overshoot
IO = IO, max; VIN, min – VIN, max, TA = 25 ^oC
Remote Sense Range
Over temperature Protection
(See Thermal Consideration section)
3.0
% VO, set
All
⎯
⎯
0.5
V
All
Tref
⎯ 125
⎯
°C
Sequencing Slew rate capability
All
dVSEQ/dt
—
2
V/msec
(VIN, min to VIN, max; IO, min to IO, max VSEQ < Vo)
Sequencing Delay time (Delay from VIN, min
to application of voltage on SEQ pin)
All
TsEQ-delay
10
msec
Tracking Accuracy
Power-up (2V/ms)
All
VSEQ –Vo
100
200
mV
Power-down (1V/ms)
VSEQ –Vo
200
400
mV
(VIN, min to VIN, max; IO, min - IO, max VSEQ < Vo)
Input Undervoltage Lockout
Turn-on Threshold
All
5.5
Vdc
Turn-off Threshold
All
5.0
Vdc
Forced Load Share Accuracy
Number of units in Parallel
-P
⎯
10
% Io
-P
5
LINEAGE POWER
4