CAR1212FP Datasheet, PDF (1/2 Pages) Lineage Power Corporation – 1200 Watt +12V Front End Power Supply

CAR1212FP Series
1200 Watt +12V Front End Power Supply
Features:
∎ Measures 11.20 x 4.00 x 1.65” / 284.5 x 101.6 x 41.9mm
∎ 12V Power for Powering Non-Isolated POL Converters
∎ Hot Swap / N+1 Redundant
∎ Active Single Wire Current Sharing
∎ Remote On/Off Control
∎ International Safety Approvals - UL, CSA, CE Mark (LVD) TUV
FEATURES
High Power Density 16W/in3
1U High Form Factor
5VSB Standby Voltage
I 2C Digital Control & Monitoring
BENEFITS
Minimizes space within your system
Supports low profile applications
Provides voltage source for housekeeping and monitoring circuitry
Cost effective power scalability
KEY MARKETS & APPLICATIONS
∎ Distributed Power ∎ Blade Servers
∎ Mid-End Servers ∎ Network Equipment
∎ Network Attached Storage
∎ Storage Area Networks
SPECIFICATIONS
Input Voltage Range
Input Current Maximum
Inrush Current
Input Protection
Power Factor
Efficiency
Output Power
Output Voltage Range
Output Current
Voltage Programming
Standby Bias Voltage
Voltage Regulation
Ouput Ripple & Noise
Transient Response
Switching Frequency
Hold-Up Time
Remote On/Off
Current Limit Protection
Short Circuit Protection
Over Voltage Protection
Operating Temperature
Over Temperature Protection
EMI
LED Indicators
Analog Status & Control
Digital Status & Control
Shock & Vibration
Dimensions
Weight
Safety Approvals
Options
rev 100506
Lineage Power
3000 Skyline Dr.
Mesquite, TX 75149
Phone: [phone]
1200 Watt +12V Front End Power Supply
85-264 VAC, 47-63 Hz
12A @ 100VAC, 8.1A @ 180 VAC, full Load
35A max. cold start (per ETS 300 132-1 and bellcore specifications)
Single Fused (Line) 20 Amp / 250 VAC Type 3AB Axial
0.99 typical complies with IEC555, EN60555-2, EN61000-3-2
89% typical at 230 VAC Full Load Operation, 85% Typical @ 90 VAC Full Load Operation
1200W at High Line Operation (230 VAC), Derate to 1000W
+12 VDC (±5%)
100A @ +12 VDC for High Line Operation (230 VAC), reduced to 83.5 A at Low Line Operation (110 VAC)
±5% of Vout nominal. Analog input signal. 11.4V + (Vprog x 0.3V) where Vprog = 0V to 4V
5VSB@500mA, reference to +12VDC Return
±2% of Vnom for any combination of line, load and temperature
ETS300 132-2, 32dBnrc. Bandwidth: 25Hz - 20kHz. 2mVrms pk-pk with 0.1µF ceramic and 10µF electrolytics caps
5% max deviation Recovery time 300µs @ 50% load step and di/dt < 1A/µs
400kHz (output)
20ms at 1200W (typical) @ 180VAC
ON if >3V or open; OFF if <1V (max. sink 1mA) Open collector type
110-135% of Iout Nominal
Self protected with auto recovery
+14.5-15.5 VDC max, latched. Reset condition by recycling AC Input or toggling remote on/off
-10°C to +70°C. power derating above 55°C at 2.5% per °C
Non latching; protection active at 110°C internal temperature, restart at 95°C (typical)
FCC-B & EN55022-B with specified filter, GR-1089-CORE
Green = AC OK & DC OK, Red = Fault
Voltage Programming (V Prog), Load sharing (I Share), Remote ON/OFF, Current Monitor (I Monitor),, Over temperature
(Temp Warning), Fault, PS Present, Module Enable
I 2C Option, see detailed specification for details
IEC68-2-27, MIL-STD-810E, Telecordia GR-63-CORE
11.20 x 4.00 x 1.65” / 284.5 x 101.6 x 41.9mm
3.0 lbs
IEC 950 per EN60950, UL60950, CSA 22.2-950, CE Mark (LVD) TUV
I2C Signals, Bezel
Lineage Power
2841 Dow Avenue

Tustin, CA 92780 USA
Phone: [phone]
Lineage Power (China)
1353 Chenqiao Road, Shanghai Sengpu Industrial Park
Shanghai, 201401 China
Phone: [phone]
w w w. l i n e a g e p o w e r. c o m / o e m