LG-192HYR-DGM-SR-CT Datasheet, PDF (12/14 Pages) LIGITEK electronics co., ltd. – LED SMD

LIGITEK ELECTRONICS CO.,LTD.
Property of Ligitek Only
PART NO. LG-192HYR/DGM-SR-CT/T10-A01
Recommended Soldering Conditions
Page 11/13
1. Hand Solder
Basic spec is ≦ 280 ℃ 3 sec one time only.
2 PB-Free Reflow Solder
1~5°C/sec
1~5°C/sec
Preheat
180~200°C
Above 220°C
60 sec.Max.
260°C MaX. 10sec.Max
6°C/sec
120 sec.Max.
Note:
1.Reflow soldering should not be done more than two times.
2.When soldering,do not put stress on the LEDs during heating.
3.After soldering,do not warp the circuit board.