LURFDGM9553-TR1 Datasheet, PDF (11/13 Pages) LIGITEK electronics co., ltd. – SURFACE MOUNT LED TAPE AND REEL

LIGITEK ELECTRONICS CO.,LTD.
Property of Ligitek Only
PART NO. LURFDGM9553/TR1
Page 10/12
Recommended Soldering Conditions
1. Hand Solder
Basic spec is ≦ 280℃ 3 sec one time only.
2. Wave Solder
Soldering heat Max. 260℃
120 ~ 150℃
Preheat
120 ~ 180 sec
245±5℃ within 5 sec
3 PB-Free Reflow Solder
1~5°C/sec
1~5°C/sec
Preheat
180~200°C
Above 220°C
60 sec.Max.
260°C MaX. 10sec.Max
6°C/sec
120 sec.Max.
Note:
1.Reflow soldering should not be done more than two times.
2.When soldering,do not put stress on the LEDs during heating.
3.After soldering,do not warp the circuit board.