LURF9S53SZ-TR1-B01 Datasheet, PDF (10/12 Pages) LIGITEK electronics co., ltd. – SURFACE MOUNT LED TAPE AND REEL

PART NO. LURF9S53SZ/TR1-B01
Recommended Soldering Conditions
LIGITEK ELECTRONICS CO.,LTD.
Property of Ligitek Only
Page 9/11
1. Hand Solder
Basic spec is ≦ 320℃ 3 sec one time only.
2. Wave Solder
Soldering heat Max. 260℃
120 ~ 150℃
Preheat
120 ~ 180 sec
245±5℃ within 5 sec
3 PB-Free Reflow Solder
1~5°C/sec
1~5°C/sec
Preheat
180~200°C
Above 220°C
60 sec.Max.
260°C MaX. 10sec.Max
6°C/sec
120 sec.Max.
Note:
1.Reflow soldering should not be done more than two times.
2.When soldering,do not put stress on the LEDs during heating.
3.After soldering,do not warp the circuit board.