FHS40-PKIT7 Datasheet, PDF (5/5 Pages) LEM – Current Transducer Evaluation PCB

Application example
According to EN 50178 and IEC 61010-1 standards and following conditions:
• Rated isolation voltage 50 V (IEC 61010-1)
• Reinforced isolation
• Over voltage category OV III
• Pollution degree PD1
• Non-uniform field
Safety
This transducer must be used in electric/electronic equipment with respect to applicable standards and safety
requirements in accordance with the manufacturer's operating instructions.
Caution, risk of electrical shock
When operating the transducer, certain parts of the module can carry hazardous voltage
(eg: primary busbar, power supply).
Ignoring this warning can lead to injury and/or cause serious damage.
This transducer is a built-in device, whose conducting parts must be inaccessible after installation.
A protective housing or additional shield could be used.
Main supply must be able to be disconnected.
070201/0 KIT N°7
Page 5/5