HC2F100-SN Datasheet, PDF (3/5 Pages) LEM – AUTOMOTIVE CURRENT TRANSDUCER HC2F100-SN CLIPS

HC2F100-SN CLIPS
Absolute maximum ratings (not operating)
Parameter
Symbol
Maximun peak primary current (not operating)
Primary nominal DC or current rms
Maximun supply voltage (not operating)
Secondary maximum admissible power
Ambient operating temperature
Ambient storage temperature
Electrostatic discharge voltage
I_{P max}
I_PN
V_{C max}
P_{S max}
T_A
T_S
V_ESD
Maximum admissible vibration
γ
Rms voltage for AC insulation test 50 Hz, 1 min
Creepage distance
V_d
dCp
Clearance
dCI
Unit
A
A
V
mW
°C
°C
V
m.s ^-2
V
mm
mm
Specification
Defined by busbar to have T° ≤ 150°C
Defined by busbar to have T° ≤ 150°C
7
150
-40 < T_A < 125°C
-40 < T_S < 125°C
2000
100
1500
1.67
1.80
Conditions
see page 5/5
see page 5/5
CTI=425
Operating characteristics
Parameter
Symbol
Primary current, measuring range
Supply voltage ¹⁾
Output voltage (Analog)
Sensitivity
Offset voltage
Current consumption
Load resistance
Output internal resistance
I_PM
V_C
V_OUT
G
V_O
I_C
R_L
R_OUT
Sensitivity error
Electrical offset
Magnetic offset
I_OE
Average temperature coefficient of
V_OE
Average temperature coefficient of G
Linearity error
Response time
Frequency bandwidth ²⁾
Output voltage noise peak-peak
Output voltage noise rms
ε_G
I_OE
V_OE
I_OM
V_OM
TCI_OEAV
TCV_OEAV
TCG_AV
ε
L
t_r
BW
V_{no p-p}
V_{no rms}
Unit
Specification
Min Typical Max
Electrical Data
A
-100
100
V
4.75
5.00
5.25
V
V_OUT = (V_C/5) x (2.5 +0.02 x I_P )
V/A
0.0196 0.02
0.0204
V
2.481
2.5
2.519
mA
-
15
20
ΚΩ
2
-
-
Ω
-
-
10
Performance Data ⁽¹⁾
%
-2.0
± 0.7
2.0
A
-0.7
± 0.25
0.7
mV
-14
±5
14
A
-0.25 ± 0.15
0.25
mV
-5
±3
5
mA/°C
-7
±4
7
mV/°C -0.14 ± 0.08
0.14
%/°C
-0.04 ± 0.02
0.04
% I_P
-1.0
± 0.2
1.0
µs
-
15
20
kHz
20
-
-
mV
-
35
43
mV
-
-
4
Conditions
@ - 40°C < T° < 125°C
@ - 40°C < T° < 125°C
@ - 40°C < T° < 125°C
@ T_A = 25°C; V_C = 5 V
@ V_C = 5 V; T_A = 25°C; I_P = 0 A
@ - 40°C < T° < 125°C; 4.75 V < V_C < 5.25 V
@ T_A = 25°C, V_C = 5 V; Gth = 0.02 V/A
@ V_C = 5.00 V; T_A = 25°C
@ After excursion to ± I_P; T_A = 25°C
@ - 40°C < T° < 125°C; V_C = 5.00 V
@ - 40°C < T° < 125°C; V_C = 5.00 V
@ I_P; V_C = 5.00 V, T_A = 25°C
@ di/dt = 50 A/µs; I_T = 60 A
@ -3 dB; I_T = 20 A rms
@ T_A = 25°C; 0 Hz < f < 1 MHz
@ T_A = 25°C; 0 Hz < f < 1 MHz
3.5
3
Notes: ¹⁾ The output voltage V_OUT is fully ratiometric. The
offset and sensitivity are dependent on the supply
2.5
voltage V_C relative to the following formula:
2
1.5
IP =  VOUT − ^VC  × ¹ × ⁵
with G in (V / A)
1

2 _ G VC
0.5
0
-100
-80
-60
-40
-20
0
@25
-20°C < T° < 85°C
- 40°C < T° < 125°C
20
40
60
80
100
Prim ary current Ip (A)
2) _{Small signal only to avoid excessive heating of}
the busbar, the magnetic core and the ASIC.
Page 3/5
18october2011/2
LEM reserves the right to carry out modifications on its transducers, in order to improve them, without prior notice.
www.lem.com