HAZ6000-SRI Datasheet, PDF (3/3 Pages) LEM – Current Transducers

Dimensions HAZ 4000..20000-SRI (in mm. 1 mm = 0.0394 inch)
FUJICON F2023A
6
1
6543 21
T.P. GND OUTPUT 0V -Vc +Vc
HAZ 10000-SRI
250 +/-1.5
235
116612162+±/±-112
200
4-D6
Terminal
M5
1...+Vc
2...-Vc
3...0V
4...OUTPUT
5...GND
6...T.P.
General tolerance +/-0.5
Connection Circuit
HAZxxx-SRI
1
2
3
4
5
6
+Vc
-Vc
0V
OUTPUT
GND
RL< 300 Ohm
T.P.
(Internal test point used
during factory calibrations)
Operation Principle
Ip
+Vc
Output
0V
-Vc
Mechanical characteristics
Safety
• General tolerance
• Aperture for primary conductor
• Transducer fastening
• Recommended fastening torque
• Connection of secondary
± 0.5 mm
162 mm x 42 mm
(± 2 mm)
4 x M5
(not supplied)
< 5 Nm
Fujicon F2023A
(6 terminals)
This transducer must be used in electric/electronic equipment
with respect to applicable standards and safety requirements
in accordance with the following manufacturer's operating
instructions.
Caution, risk of electrical shock
Remarks
• Temperature of the primary conductor should not exceed
120°C.
When operating the transducer, certain parts of the module can
carry hazardous voltage (eg. primary busbar, power supply).
Ignoring this warning can lead to injury and/or cause serious
damage.
This transducer is a built-in device, whose conducting parts
must be inaccessible after installation.
A protective housing or additional shield could be used.
Main supply must be able to be disconnected.
060428/4
LEM
LEM reserves the right to carry out modifications on its transducers, in order to improve them, without previous notice.
Page 3/3
www.lem.com