LV100-200_03 Datasheet, PDF (2/2 Pages) LEM – Voltage Transducer

Dimensions LV 100-200 (in mm. 1 mm = 0.0394 inch)
Front view
Left view
Connection
Top view
Mechanical characteristics
• General tolerance
• Transducer fastening
Fastening torque max
• Connection of primary
• Connection of secondary
• Connection to the ground
• Fastening torque max
± 0.3 mm
2 holes ∅ 6.5 mm
M6 steel screws
5 Nm or 3.69 Lb - Ft.
M5 threaded studs
Faston 6.3 x 0.8 mm
M5 threaded stud
2.2 Nm or 1.62 Lb. -Ft.
Remarks
•
I
S
is
positive
when
V
P
is
applied
on
terminal
+HT.
• The primary circuit of the transducer must be linked to the
connections where the voltage has to be measured.
• This is a standard model. For different versions (supply
voltages, turns ratios, unidirectional measurements...),
please contact us.
LEM reserves the right to carry out modifications on its transducers, in order to improve them, without previous notice.