LV100-100 Datasheet, PDF (2/2 Pages) LEM – Voltage Transducer LV 100-100

Dimensions LV 100-100 (in mm. 1 mm = 0.0394 inch)
Front view
Left view
Secondary terminals
Terminal + : supply voltage + 15 V
Terminal M : measure
Terminal - : supply voltage - 15 V
Terminal : ground or earth
Connection
Top view
Mechanical characteristics
•General tolerance
•Fastening
•Connection of primary
•Connection of secondary
•Connection to the ground
•Fastening torque
± 0.3 mm
2 holes ∅ 6.5 mm
M5 threaded studs
Faston 6.3 x 0.8 mm
M5 threaded stud
2.2 Nm or 1.62 Lb. -Ft.
Remarks
•I_S is positive when V_P is applied on terminal +HT.
•The primary circuit of the transducer must be linked to the
connections where the voltage has to be measured.
•This is a standard model. For different versions (supply
voltages, turns ratios, unidirectional measurements...),
please contact us.
LEM reserves the right to carry out modifications on its transducers, in order to improve them, without previous notice.