LT10000-S_03 Datasheet, PDF (2/2 Pages) LEM – Current Transducer

Dimensions LT 10000-S (in mm. 1 mm = 0.0394 inch)
Front view
Left view
Connection
Mechanical characteristics
Remarks
• General tolerance
• Transducer fastening
Recommended fastening torque
• Primary through-hole
• Connection of secondary
Recommended fastening torque
± 1 mm
4 holes ∅ 11 mm
4 x M10 steel screws
11.4 Nm or 8.48 Lb - Ft
∅ 200 mm
M5 threaded studs
2.2 Nm or 1.62 Lb - Ft
• I_S is positive when I_P flows in the direction of the arrow.
• Temperature of the primary conductor should not exceed
100°C.
• Dynamic performances (di/dt and response time) are best
with a primary bar in the center of the through-hole.
• This is a standard model. For different versions (supply
voltages, turns ratios, unidirectional measurements...),
please contact us.
LEM reserves the right to carry out modifications on its transducers, in order to improve them, without previous notice.