HX02-P Datasheet, PDF (2/2 Pages) LEM – Current Transducer

Dimensions HX 02..06-P (in mm. 1 mm = 0.0394 inch)
HX^HHXX0⁰⁰²3^.2..^0..⁶².^-2^5P-5^P-P
19 Max.
HXHX5500-PP
Terminal Pin Identification
19 Max.
1 ..... -15 V
2 ..... 0 V
3 ..... +15 V
4 ..... Output
5 ..... Primary input Current (+)
6 ..... Primary input Current (-)
3
10.85
d
4 OUT
6
3 +V
20
1 -V or 0
5
3
10.85
Terminal Pin Identification
1.....-15V
2.....0V
3.....+15V
4.....Output
5.....Primary input Current(+)
6.....Primary input Current(-)
Primary conductor diameter
3
8.8
5.4
HX 02-P 03-P 04-P 06-P
d 0.56
0.6
0.7
1.0
4 OUT
65
3_S+_eV_{condary pins dimension}
2_0.0_{5 x 0.25}
1 -V or 0
1.2
3
8.8
5.4
Top view
H_HX_X 0₀₂5_--_PP
41123
Lot No.
Primary conductor diameter / dimension
Safety
HX 03-P 05-P 10-P 15-P 20-P 25-P 50-P
d 0.6 0.8 1.1 1.4 1.6 1.6 1.2x6.3
Secondar_Ty_hp_isins_tradi_nm_se_dn_us_cio_en_{r must be used in electric/electronic equipment}
0.5x0_w.2_i5_{th respect to applicable standards and safety requirements}
in accordance with the following manufacturer's operating
instructions.
Caution, risk of electrical shock
When operating the transducer, certain parts of the module can
carry hazardous voltage (eg. primary busbar, power supply).
Ignoring this warning can lead to injury and/or cause serious
damage.
This transducer is a built-in device, whose conducting parts
must be inaccessible after installation.
A protective housing or additional shield could be used.
Main supply must be able to be disconnected.
060920/1
LEM reserves the right to carry out modifications on its transducers, in order to improve them, without prior notice.
Page 2/2
www.lem.com