CV3-500 Datasheet, PDF (2/2 Pages) LEM – Voltage Transducer

Dimensions CV 3-500 (in mm. 1 mm = 0.0394 inch)
Front view
Left view
Secondary terminals
Terminal + : supply voltage + 15 V
Terminal M : measure
Terminal 0 : 0 V
Terminal - : supply voltage - 15 V
Connection
Top view
Mechanical characteristics
• General tolerance
• Fastening
• Connection of primary
• Connection of secondary
• Fastening torque
± 0.3 mm
3 holes ∅ 5.5 mm
M5 threaded studs
M5 threaded studs
2.2 Nm or 1.62 Lb. -Ft.
Remarks
• V_S is positive when V_P is applied on terminal +HT.
• CEM tested with a shielded secondary cable.
Shield connected to 0 V at both ends, or disconnected.
• This is a standard model. For different versions (supply
voltages, turns ratios, unidirectional measurements...), please
contact us.
LEM reserves the right to carry out modifications on its transducers, in order to improve them, without previous notice.