AHR-B5 Datasheet, PDF (1/3 Pages) LEM – AC/DC Current transducer

AC/DC Current transducer AHR-B5
The transducer for the electronic measurement of DC & distorted AC
waveform currents, with galvanic isolation between the primary circuit
(power) and the secondary circuit (measurement).
True RMS 0-5 V voltage output.
I_PN = 500 .. 2000 A
Electrical data
Primary nominal
DC & AC current
I_PN (At rms)
500
800
1000
1500
2000
Primary AC current
max. peak value ¹⁾
I_P (A)
2000
2500
2000
2500
3000
Output voltage
(Analog)
V_OUT (VDC)
0-5
0-5
0-5
0-5
0-5
R_L
Load resistance
V_C
Supply voltage
I
Current Consumption
C
V_SL
Output voltage limitation
Î
Overload capability (Ampere Turns)
P
Performance data
X
ε_L
V_OE
TCV
OE
TCV
OUT
t_r
BW
Accuracy @ I_PN, T_A = 25°C (excluding offset)
Linearity error (1% of I_PN .. ± I_PN)
Electrical offset voltage, T_A = 25°C
Temperature coefficient of V (0 .. + 60 °C)
OE
(- 40 .. + 70 °C)
Temperature coefficient of V (% of reading)
OUT
Response time to 90% of I_PN step
Frequency bandwidth (±1 dB)
General data
T_A
T
S
m
IPxx
Ambient operating temperature
Ambient storage temperature
Mass
Protection degree
Type
AHR 500 B5
AHR 800 B5
AHR 1000 B5
AHR 1500 B5
AHR 2000 B5
≥ 10
kΩ
+ 20 .. 50 V DC
35
mA
<7
V
30000
At
< ± 1 % of I_PN
< ± 1.0 % of I_PN
< ± 1.0 % of I_PN
± 2.0 mV/K
± 4.0 mV/K
± 0.15 %/K
< 150
ms
DC, 20 .. 6000Hz
- 40 .. + 70 °C
- 40 .. + 85 °C
650
g
IP20
Features
• DC + distorted AC waveform currents
measurement
• True RMS output
• Busbar or panel mounting
• Split core type
• Insulated plastic case recognized
according to UL94-V0.
Advantages
• High isolation between primary and
secondary circuits
• Eliminates insertion loss
• Easy installation.
Applications
• AC power supplies or Motors:
True RMS current sensing - the most
accurate way to monitor power supply
or motor input power
• VFD Controlled Loads:
VFD output current monitoring to
indicate how the motor and the
attached load are operating
• SCRs or Switch-mode Rectifiers:
Accurate measurement of output
current
Note :
1) _{The max. peak AC current is the highest peak level of the primary signal that is}
taken into account for accurate True r.m.s. calculation.
Yet the device is designed for maximum continuous true r.m.s. value equal to I_PN,
whereas the output is limited by the above specified output limitation.
• Renewable Energy Installations or
Backup Batteries:
Continuous condition minitoring
allowing automatic failure detection/
anticipation.
Application domain
061128/6
• Energy and Automation
LEM reserves the right to carry out modifications on its transducers, in order to improve them, without prior notice.
Page 1/3
www.lem.com