ML610Q411 Datasheet, PDF (1/36 Pages) List of Unclassifed Manufacturers – 8-bit Microcontroller with a Built-in LCD driver

ML610Q411/Q412
8-bit Microcontroller with a Built-in LCD driver
FEDL610Q411-04
Issue Date: July.13, 2015
GENERAL DESCRIPTION
ML610Q411/Q412 is a high-performance 8-bit CMOS microcontroller into which rich peripheral circuits, such as synchronous
serial port, UART, I²C bus interface (master), buzzer driver, battery level detect circuit, RC oscillation type A/D converter,
12-bit successive approximation type A/D converter, and LCD driver, are incorporated around LAPIS Semiconductor -original
8-bit CPU nX-U8/100.
The CPU nX-U8/100 is capable of efficient instruction execution in 1-intruction 1-clock mode by 3-stage pipe line architecture
parallel procesing. The Flash ROM that is installed as program memory achieves low-voltage low-power consumption operation
(read operation) equivalent to mask ROM and is most suitable for battery-driven applications. The on-chip debug function that
is installed enables program debugging and programming.
M L610Q411/Q412 has a dual clock, runs at 32.768kHz crystal oscillation clock or a built-in 500kHz RC oscillation clock, used
for a system requires the accurate clock or timer.
FEATURES
• CPU
− 8-bit RISC CPU (CPU name: nX-U8/100)
− Instruction system: 16-bit instructions
− Instruction set: Transfer, arithmetic operations, comparison, logic operations, multiplication/division, bit
manipulations, bit logic operations, jump, conditional jump, call return stack manipulations, arithmetic
shift, and so on
− On-Chip debug function
− Minimum instruction execution time
30.5 µs (@32.768 kHz system clock)
2µs (@500kHz system clock)
• Internal memory
− Internal 16KBbyte Flash ROM (8K×16 bits) (including unusable 1KByte TEST area)
− Internal 1KByte Data RAM (1024×8 bits)
• Interrupt controller
− 2 non-maskable interrupt sources
Internal source: 1 (Watch dog timer)
External source: 1 (NMI)
− 19 maskable interrupt sources
Internal sources: 15 (SSIO, SA-A/D converter, I2C, Timer0, Timer1, Timer2, Timer3, 1kHz timer, UART, RC-A/D
converter, PWM, TBC128Hz, TBC32Hz, TBC16Hz, TBC2Hz)
External sources: 4 (P00, P01, P02, P03)
• Time base counter
− Low-speed time base counter ×1 channel
Frequency compensation (Compensation range: Approx. −488ppm to +488ppm. Compensation accuracy: Approx.
0.48ppm)
− High-speed time base counter ×1 channel
1/36